Step 3 - Preparing The Chainsaw For Use Following Storage - Qualcast 46 cc Petrol Chainsaw Operating Instructions Manual

Storing the Chainsaw
Step 2 - Storing the Chainsaw for Extended Periods (continued)
2c. Start the Chainsaw
Start the chainsaw as described on page 23 and allow it to run until it stops. This will ensure any fuel
in the carburettor is used.
2d. Oil the Combustion Chamber
Allow the engine to cool (approx. 5 minutes).
Remove the spark plug as described on page 42.
Carefully pour one teaspoon of clean unused 2-cycle oil into the combustion chamber.
Pull the starter cord several times to ensure the 2-cycle oil covers all the internal components.
Replace the spark plug as described page 42.
Before the chainsaw can be used following extended storage, the following procedures
must be performed.
Store the unit in a dry place away from possible sources of ignition such as a furnace,
gas hot water heater, gas dryer, etc.

Step 3 - Preparing the Chainsaw for Use Following Storage

3a. Remove the Spark Plug
Remove the spark plug as described page 37.
3b. Clear the Combustion Chamber
Pull the starter cord several times to ensure the 2-cycle oil is expelled from the combustion chamber.
3c. Check the Spark Plug Electrode Gap
Carefully clean the spark plug as described page 37 and ensure the electrode gap (approx. 0.6mm
is correct).
3d. Refit the Spark Plug
Refit the spark plug as described page 42.
3e. Prepare the Chainsaw for Use
Prepare the chainsaw for use as described on page 15 to 20.
Customer Helpline 0151 649 1500
35