Docomo Arrows X F-10D Instruction Manual page 105

❖
Radio wave interference with wireless
LAN
Because a Bluetooth device and wireless LAN
(IEEE802.11b/g/n) use the same frequency band (2.4 GHz),
if the device is used near a device with wireless LAN
capability, radio wave interference may occur, and
communication speed may be reduced, noise may occur,
or connection may not be established. In this case, turn the
wireless LAN device power off, or move the terminal and
the Bluetooth device away at least 10 m from the wireless
LAN device.
Bluetooth function ON/OFF
Set Bluetooth to ON to use Bluetooth function. When you
do not use Bluetooth, set it to OFF in order to cut the
battery power consumption.
When activated, appears on the status bar.
Turning the power OFF does not change Bluetooth ON/
OFF setting.
From the Home screen, m [Settings]
1
[Bluetooth] to [ON]/[OFF]
When the screen about aptX appears, tap [OK].
You can also set Bluetooth to ON/OFF by the setting
switch on the Notification panel.
Connecting with registered
Bluetooth devices
Connect Bluetooth device. You can talk or play back
sounds or music using a Bluetooth device, or exchange
data to or from a Bluetooth device. And you can enter
characters on the terminal with Bluetooth compatible
keyboard.
Set a Bluetooth device to connection stand-by mode in
advance.
When connected,
From the Home screen, m [Settings]
1
[Bluetooth]
If Bluetooth devices do not appear, tap[Not visible
to other Bluetooth devices]/[Only visible to paired
devices] to switch to [Visible to all nearby Bluetooth
devices], then tap [SEARCH FOR DEVICES].
2
Tap a Bluetooth detected Enter a pass
code (PIN) if necessary, [OK]/[Pair]
When connection is requested from another
Bluetooth device
If a Bluetooth pair setting request screen appears, enter a
pass code (PIN) if necessary and tap [OK], or tap [Pair].
✔INFORMATION
A message notifying that communication charges may
become high appears when connecting with DUN (Dial-
Up Network Profile).
103
appears on the status bar.
File management