Commissioning - Emerson 1420 Reference Manual

Reference Manual
00809-0100-4420, Rev BA
August 2007
Section 2

COMMISSIONING

Initial Configuration
Commissioning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 2-1
Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 2-6
Return PC/Laptop to Original Settings . . . . . . . . . . . . . . . page 2-11
Explosions could result in death or serious injury:
• In an Explosion-Proof and Flame-Proof environment, do not open the 1420
Wireless Gateway electronic housing in an explosive atmosphere.
To configure the 1420 Wireless Gateway, a local connection between a
PC/laptop and the 1420 Wireless Gateway must first be established. This can
be done with the crossover cable and a PC/laptop dedicated to the 1420
Wireless Gateway, or a PC/laptop used for another purpose can be
temporarily configured for the task.
HINT/TIP
If a PC/laptop from another network is used, carefully record the
current IP address and other settings so the PC/laptop can be
returned to its original network when configuration of the 1420
Wireless Gateway is finished.
If using a PC/laptop attached to another network, shut down the PC/laptop
and remove it from the network before proceeding to set up the 1420 Wireless
Gateway local connection.
PC/Laptop
Crossover Cable
1420 Wireless Gateway
24 V DC 24 V DC
Power Input Power Input
+ -
Case Case
POE POE
(Covered) (Covered)
Modbus Modbus Not Used Not Used Not Used Not Used
S S A B + - S S - +
+ - S S - +
P2 P2 P1 P1 Not Used Not Used Not Used Not Used
P1 Ethernet
Receptacle
2-1