Dwell Sub-Menu - Baxall DVS14 Installation And Operating Manual

DVS Series
The Dwell sub-menu is used to specify the dwell time for each individual camera input
when a sequence is performed on the main monitor. If the switcher is a DVS24A or DVS28A,
this sub-menu is also used to set the global dwell time, which is applied to every camera
input in a sequence on the second monitor (also called the spot monitor).
S
1
2
3
4
5
6
7
8
EXIT
(For the DVS28A)
The Dwell sub-menu has a numbered field for each camera input, and each of these fields
indicates a dwell time (in seconds). To alter the dwell time of an individual camera input,
use the and buttons to select the required camera input, and use the
to adjust the dwell time (between 1 and 60 seconds).
If there are any camera inputs that are not to be included in the sequence, set the dwell
time to zero.
On the DVS24A and DVS28A switchers, there is also a field labelled S. This field is used to
set the global dwell time, which is applied to every camera input in sequence on the second
monitor. To alter the global dwell time in the same way, use the
the field labelled S and use the
seconds).
CAUTION
Do not set the dwell time of all inputs to 0 seconds as this can cause the unit to
freeze.
16
DWELL
05
02
05
09
20
18
00
00
00
Figure 12 - Dwell Sub-Menu
and buttons to adjust the dwell time (between 5 and 60
Installation and Operating Manual
DWELL
1
2
3
4
5
6
7
8
EXIT
(For the DVS18)
and

DWELL SUB-MENU

02
05
09
20
18
00
00
00
and buttons
buttons to select