Dimplex TDS8515T Installation And Operation Manual page 4

REMOTE CONTROL USAGE
This stove is supplied with a radio frequency remote control. This remote control has a range
of approximately 50 feet (15.25m), it does not have to be pointed at the fireplace and can pass
through most obstacles (including walls). It is supplied with one of 243 independent
frequencies to prevent interference with other units. The frequency code is indicated on the
back of the transmitter.
FIGURE 2
FIGURE 3
A. Remote Control Initialization
This procedure is required every time there is a loss
of power to the remote control in the fireplace.
(i.e. power failure, breaker tripped, main power switch
is turned off)
1. Ensure that power is supplied through main
service panel.
2. Locate manual controls. (refer to FIGURE 3)
3. Activate main power switch, (" " position) red
indicator light 1 will flash.
4. Press and hold the manual selection switch for five
Frequency
seconds (" " position) UNTIL the second red
Code
indictor light flashes.
5. Press ON button located on the remote control
transmitter (FIGURE 2). This will synchronize the
remote control transmitter and receiver.
B. Remote Control Usage
The remote control operates the fireplace levels
sequentially. The level is increased every time the
ON button on the transmitter is pressed. The
Main
fireplace can be turned off at any point by pressing
Power
the OFF button on the remote control transmitter.
Switch
Level 1: The flame effect is turned on and the first red
Level 2: The flame effect remains on, the Purifire™
Manual
Selection
Switch
Level 3: The flame effect and Purifire™ remain on,
Interior
Light
Switch
indicator light is activated.
is activated, and the first and second red
indicator lights are activated.
the heater is activated, and all three red
indicator lights are activated.
3
FIGURE 4
Level 1 Indicator
Level 2 Indicator
Level 3 Indicator