Advertisement
Installation
Determining the Best Location for the A300 Audio Greeter
The A300 should be mounted on a vertical wall about 60 inches high. If the user must bend over a countertop to
reach the A300, then lower it to 50 inches so the user can speak directly into the on-board microphone.
A quiet location is recommended if frequent voice recording is anticipated. A nearby manager's office or other
enclosed room would be ideal. Cable runs over 35 feet should be avoided to reduce signal degradation.
Mounting Hardware (not supplied)
4 each, #8 screws
4 each, wall anchors
Mounting the A300 Audio Greeter
Before mounting the A300 to the wall, we recommend that you attach all the cables to the A300 while it rests on a
countertop or a chair near its mounting surface. This allows easy access to all jumpers and controls with the cover
open.
1. Remove the A300 cover and unplug the switch panel ribbon cable from the main circuit board.
2. Place the A300 at the desired location 50" to 60" high. Mark the locations of the four holes in the base onto
the mounting surface.
3. Using appropriate mounting hardware (not supplied), attach the A300 base to the mounting surface.
4. Plug the ribbon cable into the main circuit board and attach the cover.
5. Clean the left-hand side of the cover with denatured alcohol and attach the external microphone holder using
the double-stick tape provided.
6. Attach the wire cover to the right side of the A300 using the screws provided.
If it is necessary to operate the A300 with the cover removed while it is
mounted on a vertical wall, do not allow the cover to hang from the switch
panel ribbon cable. The cover may rest on the top edge of the base plate,
but make sure it doesn't fall off.
Installation Diagrams
Figure 1. "Installing the A300 Audio Greeter with the 3M D-15 Intercom"
Figure 2. "Installing the A300 Audio Greeter with the 3M Interconnect Module"
Figure 3. "Installing the A300 Audio Greeter with the 3M C762AA/BA/C921AA Base Station"
Figure 4. "Installing the A300 Audio Greeter with the 3M C921BA Base Station"
Figure 5. "Installing the A300 Audio Greeter with the HME SYS2500D/DS/DSL Base Station"
Figure 6. "Installing the A300 Audio Greeter with the HME WBS2000 Base Station"
Figure 7. "Installing the A300 Audio Greeter with the Panasonic WX-C510/WX-C1010 Base Station"
Figure 8. "Optional Installation with the HME or Panasonic Base Station"
Figure 9. "Installing the A300 Audio Greeter with an Intercom Using an Outside Speaker/Microphone"
Figure 10. "Installing the A300 Audio Greeter with the 3M Sodar Vehicle Detector"
Important
!
2
Advertisement
