Commissioning Certificate - XFP NETWORKABLE ANALOGUE ADDRESSABLE FIRE ALARM CONTROL PANEL User Manual

Log book

Hide thumbs

Table Of Contents

Table of Contents

XFP NETWORKABLE ANALOGUE ADDRESSABLE FIRE ALARM PANEL

BS5839-1:2002 recommends that certificates be issued for all aspects of the fire alarm system including design,

BS5839-1:2002 recommends that certificates be issued for all aspects of the fire alarm system including

installation, commissioning, acceptance, verification (optional) and maintenance. Therefore, before this user manual

design,installation, commissioning, acceptance, verification (optional) and maintenance. Therefore, before this

is handed over, the following commissioning certificate and the installation certificate (overleaf) should be

user manual is handed over, the following commissioning certificate and the installation certificate (overleaf)

completed as appropriate by the relevant installation/commissioning engineer(s). Please ensure that the system set-up

should be completed as appropriate by the relevant installation/commissioning engineer(s). Please ensure that the

data chart on page 13 and the relevant parts of the Log Book on page 14 are also completed as appropriate.

system set-up data chart on page 20 and the relevant parts of the Log Book on page 21 are also completed as

For countries outside the UK, different certification requirements may apply.

Certificate

appropriate. For countries outside the UK, different certification requirements may apply.

Address:

_________________________________________________________________________

I/we being the competent person(s) responsible (as indicated by my/our signatures below) for the commissioning of the

fire alarm system, particulars of which are set out below, CERTIFY that the said work for which I/we have been responsible

complies to the best of my/our knowledge and belief with the specification described below and with the recommendations

of Clause 39 of BS5839-1: 2002, except for the variations, if any, stated in this certificate.

Name (in block letters):

Position (in block letters):

Signature:

Date:

For and on behalf of:

Address & postcode:

The extent of the liability of the signatory is limited to the system described below.

Extent of system covered by this certificate:

______________________________________________________________________________________

Variations from the recommendations of Clause 39 of BS5839-1:2002 (see BS5839-1:2002, Clause 7):

______________________________________________________________________________________

All equipment operates correctly

Installation work is, as far as can reasonably ascertained, of an acceptable standard

The entire system has been inspected and tested in accordance with the recommendations of 39.2c of

BS5839-1:2002.

The system performs as required by the specification prepared by: ________________________________

a copy of which I/we have been given.

Taking into account the guidance contained in Section 3 of BS 5839-1:2002, I/we have not identified

any obvious potential for an unacceptable rate of false alarms.

The documentation described in Clause 40 of BS5839-1:2002 has been provided to the user.

The following work should be completed before/after (delete as applicable) the system becomes operational:

______________________________________________________________________________________

The following potential cause(s) of false alarms should be considered at the time of the next service visit:

______________________________________________________________________________________

Before the system becomes operational, it should be soak tested in accordance with the recommendations of 35.2.6 of

BS5839-1:2002 for a period of: _________________ (enter a period of either one week, such period as required by the

specification, or such period as recommended by the signatory of this certificate, whichever is the greatest, or delete if not applicable).

XFP USER MANUAL & LOG BOOK • Approved Document No. DFU2000501 Rev 2 • Page 28 of 28

of COMMISSIONING

for the fire alarm system at:

____________________________________________________________

CFP USER MANUAL • Approved Document No. DFU7001000 Rev 4

Table of Contents

Commissioning Certificate - XFP NETWORKABLE ANALOGUE ADDRESSABLE FIRE ALARM CONTROL PANEL User Manual

Related Manuals for XFP NETWORKABLE ANALOGUE ADDRESSABLE FIRE ALARM CONTROL PANEL

Related Content for XFP NETWORKABLE ANALOGUE ADDRESSABLE FIRE ALARM CONTROL PANEL

Table of Contents