Table of Contents
Advertisement
XFP NETWORKABLE ANALOGUE ADDRESSABLE FIRE ALARM PANEL
ACCESS LEVEL 1 (General User) CONTROLS & MENU OPTIONS
Access level 1 is the normal user level which is accessible to everyone. At this level you can:-
• Scroll through any fire, pre-alarm and fault conditions (as described on pages 8-11)
• View any disablements or zones that are being tested (if applicable)
• Test the panel's lamps (its LED indicators and display) to ensure they are working correctly
• Determine the total number of times the panel has been in a fire condition
• Gain entry to access level 2 (authorised user level) and, if you are an engineer, access level 3.
Pressing the panel's MENU button at access level 1 activates the panel's general user menu which can
be navigated using the panel's scroll (
menu options available at access level 1 are explained in detail over the next two pages.
ENTER ACCESS LEVEL 2
ENTER ACCESS LEVEL 3
DISPLAY FIRE EVENTS
DISPLAY FAULT EVENTS
DISPLAY DISABLEMENTS
DISPLAY ZONES IN TEST
LAMPS TEST
DISPLAY ALARM COUNTER
Enter Access Level 2
Access level 2 is for authorised users only and access to it requires the input of a special four digit code.
THIS MENU OPTION WILL NOT BE APPEAR ON KEYSWITCH VERSIONS OF THE PANEL WHERE ENTRY
TO ACCESS LEVEL 2 IS GAINED BY TURNING THE PANEL'S KEYSWITCH TO THE ARMED POSITION .
On push button panels, when the ENTER ACCESS LEVEL 2? prompt appears, press the accept
button and you will be asked to enter the code:
Enter Access Level 2 code:
Enter the code using the
level 2 is 3 3 3 3 (four presses of the
by an authorised user/engineer. A record of any changes should appear on the System Setup Data
Chart on page 20 of this user manual. If they do not, contact your maintenance company for advice.
As soon as the code has been entered correctly you will be taken into access level 2. Additional
panel controls (see page 14) and menu options (see pages 15-19) will now be available to you.
Enter Access Level 3
Access level 3 is the panel's engineering/programming level. ON NO ACCOUNT SHOULD ACCESS
LEVEL 3 BE ACCESSED BY ANYONE BUT AN AUTHORISED SYSTEM ENGINEER. A FIRE PANEL IS A PIECE
OF LIFE SAFETY EQUIPMENT AND UNAUTHORISED ACCESS MAY AFFECT THE WAY THE PANEL
FUNCTIONS, ENDANGER LIFE AND VOID ITS WARRANTY. If you are an authorised engineer, details of
access level 3 can be found in the panel's separate Engineering manual.
Display Fire Events
This function is only available if there are active fire conditions on the system. If available, press the
accept
button once and a window similar to the one below will appear:-
Last Zone: 1:North Stairs
XFP USER MANUAL & LOG BOOK • Approved Document No. DFU2000501 Rev 2 • Page 12 of 28
), accept (
(1)
(2)
(3)
(4) buttons as appropriate. The default code to access
button). If this does not work, the code may have been changed
:Fire!
1 Zone
) and escape (
) buttons as appropriate. The
Note that menu options shown in
bold will only appear if relevant to
the panel's status. For example, the
DISPLAY FIRE EVENTS function will
not show if there are no active fire
conditions on the system.
Advertisement
Table of Contents
