Finding The Beginning Of A Tune - JVC KS-LX200R Instructions Manual

To play back tapes recorded with the
Dolby B NR
1 Press MODE ATT.
"MODE" appears on the display.
2 Press MO/
display so that the
and "DOLBY B" appears on the display for
several seconds.
To cancel the Dolby B NR, repeat the above
procedure again so that the
off.
* Dolby noise reduction is manufactured under
license from Dolby Laboratories Licensing
Corporation.
"DOLBY" and the double-D symbol
trademarks of Dolby Laboratories Licensing
Corporation.
Prohibiting tape ejection
You can prohibit tape ejection and can "lock" a tape
in the cassette compartment.
Press and hold SOURCE (23) and 0 OFF for more
than 2 seconds. "NO EJECT" flashes on the display
for about 5 seconds, and the tape is "locked."
To cancel the prohibition and "unlock" the tape,
press and hold SOURCE (23) and 0 OFF for
more than 2 seconds again. "EJECT OK" flashes
for about 5 seconds, and this time the tape is
"unlocked."
Note:
If you press 0 OFF while tape ejection is prohibited,
the display panel moves down, but the tape cannot be
ejected. ("NO EJECT" appears on the display.)
To move up the display panel, press
16
while "MODE" is still on the
indicator lights up,
indicator goes
¢ or 4

Finding the beginning of a tune

Multi Music Scan allows you to automatically start
playback from the beginning of a specified tune.
You can specify up to 9 tunes ahead of or before
the current tune.
During playback
Specify how many tunes ahead of or
before the current tune the one you want
is located.
Press
of the current tune on the tape.
are
Each time you press the buttons, the number
changes up to ±9.
When the beginning of the specified tune is located,
playback starts automatically.
Notes:
• While locating a specified tune:
– If the tape is rewound to its beginning, playback starts
from the beginning of that side.
– If the tape is fast-forwarded to the end, it is reversed
and played from the beginning of the other side.
• In the following cases, the Multi Music Scan function
may not operate correctly:
– Tapes with tunes having long pianissimo passages
(very quiet parts) or non-recorded portions between
tunes.
– Tapes with short non-recorded sections.
– Tapes with high level of noise or humming between
tunes.
.
– The Dolby NR setting does not match. For example,
if Dolby B NR is on and the tape was recorded with
no Dolby NR.
¢ to locate a tune ahead
Press 4
to locate a tune
before the current tune on the tape.