Gigaset C 100 User Manual page 76

What has happened
when ...
... an internet address appears
in the display?
... (when using more than one
handset) the handset that is in
the base does not charge?
... the handset or the base
C 150 does not ring?
... I can hear no ringer tone/
dial tone?
... the other party cannot hear
me?
... the incoming call number is
not displayed even though
CLIP is set?
... I hear an error tone (falling
tone sequence) when keying
an input?
... the caller list does not indi-
cate a time for a message?
... the answering machine
reports "PIN is incorrect" dur-
ing remote operation?
... the answering machine
does not record any messages
or has automatically switched
over to 'announce only'?
Possible cause
The automatic registration of
your handset to the base has
been interrupted.
The base will not charge the
handset if telephoning is simul-
taneously in progress.
The ringer is switched off.
You have changed the telephone
cord on your Gigaset.
You have pressed the INT key.
This mutes the handset.
Calling line identification is not
enabled.
The action has failed or the input
is incorrect.
Date/time are not set.
The entered system PIN is incor-
rect or set to 0000.
The memory is full.
Possible solution
Register your handset manu-
ally (page 56).
Use an additional charger.
Switch on the ringer in the
handset (page 62) or base
C 150 .
When purchasing a new cord
ensure that it has the correct
pin assignment (page 7).
Switch on the microphone
again (page 18).
The caller should ask his net-
work provider to enable the
identification of his number
(CLI).
Repeat the procedure; watch
the display and if necessary
refer to the operating instruc-
tions.
Set the date/time (page 14).
Enter the system PIN again or
set a PIN that is different from
0000 (page 66).
Delete old messages
Play back and delete new mes-
sages.
Appendix
73