Teb Fan; Truma Ultraheat For S 3002 (P), S 5002 And S 55 T Heaters - Swift Vehicle Owner's Manual

Fitted Equipment

TEB FAN

Always observe the operating
instructions prior to starting!
The vehicle owner is responsible for the
correct operation of the appliance.
Repairs are only to be carried out by an
expert!
a = Manual control
(e.g. for ventilation) Adjust desired output
at the control knob.
b = Off
(or automatic operation/ heating with
heaters Trumatic S 3002 K and S 5002 K)
c = Automatic operation
(Heating) The output steadily adjusts to
70
the respective heat emission of the
heater. The maximum output can be
limited at the control knob, as required.
The regulating between this value and
slow running is carried out automatically.
The quantity of air can be individually
adjusted at the air flap (f), for warm air
distribution.
In centre position 50% of the warm air is
distributed to each outlet.
Use the fan duct with 72 mm and if the fan
ducts are of different lengths or on sides with
a greater heat requirement. This means that
the air output can be used to the full on this
side. By adjusting the air flap (f) the quantity
of air can be increased individually. This
means that the air out-put on the other side
is reduced.
If the air output drops or the operating noise
increases, the fan impeller wheel may be
severely soiled.
Cleaning
(with switched off appliance!) We
recommend removing dust which has
collected on the heat exchanger and base
plate of the heater and on the impeller wheel
of the Trumavent fan, once a year before the
heating season starts. Clean the impeller
wheel carefully using a brush or tooth brush.
TRUMA ULTRAHEAT ADDITIONAL
ELECTRIC HEATING FOR
TRUMATIC S 3002 (P), S 5002
AND S 55 T HEATERS
Function description
Truma-Ultraheat is an additional 230V
electric heater for the LPG heater models
Trumatic S 3002/S 5002.
Heater operation is basically possible with
gas only, electricity only or simultaneously
with electricity and gas.
When using simultaneously the electrical unit
will switch itself off before overheating
occurs as a result of the stronger gas burner.
When using electrical only we recommend to
set the fan control on position 3 (manual or
auto), remembering to set the output level to