Table of Contents
Advertisement
KS-F345
Installation/Connection Manual
GET0112-002A
[EE]
ENGLISH
• This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems.
INSTALLATION (IN-DASH MOUNTING)
• The following illustration shows a typical installation. However, you should make adjustments corresponding
to your specific car. If you have any questions or require information regarding installation kits, consult your
JVC IN-CAR ENTERTAINMENT dealer or a company supplying kits.
1
Before mounting: Press
(control panel release button) to detach the control panel if already
attached.
* When shipped from the factory, the control panel is packed in the hard case.
2
Remove the trim plate.
3
Remove the sleeve after disengaging the sleeve locks.
1 Stand the unit.
Note: When you stand the unit, be careful not to damage the fuse on the rear.
2 Insert the 2 handles between the unit and the sleeve, as illustrated, to disengage the sleeve locks.
3 Remove the sleeve.
Note: Be sure to keep the handles for future use after installing the unit.
4
Install the sleeve into the dashboard.
* After the sleeve is correctly installed into the dashboard, bend the appropriate tabs to hold the sleeve
firmly in place, as illustrated.
5
Fix the mounting bolt to the rear of the unit's body and place the rubber cushion over the end of the bolt.
6
Do the required electrical connections.
7
Slide the unit into the sleeve until it is locked.
8
Attach the trim plate.
9
Attach the control panel.
1
Control panel
3
Handle
Slot
Fuse
Sleeve
Lock Plate
Control panel
1
2
3
1
2
3
4
5
6
7
8
9
2
Trim plate
Rubber cushion
Sleeve
7
8
9
Trim plate
1
V
J
Dashboard
1 8
4
m
m
4
5 3
m
m
5
Mounting bolt
6
4
*
See "ELECTRICAL CONNECTIONS."
1202KKSMDTJEIN
C
EN, RU
Advertisement
Table of Contents
