Roof Rack/Ski Rack; Headlights - Fiat 500 Abarth Owner's Handbook Manual

ROOF RACK/SKI RACK

FASTENERS
The fasteners are located in the area in-
dicated in fig. 55.
To use the front fasteners, remove the cap
A, accessible with the door open. To lo-
cate rear fasteners B, refer to fig. 56.
Lineaccessori provides a specific rack/ski
rack on tailgate.
IMPORTANT Follow the instructions
contained in the assembly kit to the letter.
Assembly must be performed by qualified
personnel.
WARNING
Comply with applicable laws
concerning maximum over-
all dimensions.
Evenly distribute the load and
take into account, when dri-
ving, the increased respon-
siveness of the car to side
wind.
A
fig. 55
B
fig. 56
WARNING
After travelling for a few
kilometres, check again that
fastening screws are properly tight-
ened.
Never exceed the maximum
allowed load (see "Technical
Specifications").

HEADLIGHTS

BEAM DIRECTION
The correct orientation of the headlights
is important for drivers comfort and safe-
ty. Besides, it is a specific rule of the high-
way code.
The headlights must be correctly directed
F0S055Ab
to ensure the best visibility conditions for
all drivers.
Contact Abarth Dealership to have the
headlights properly adjusted.
Check beam aiming every time the load or
its distribution changes.
IMPORTANT When turning on (Xenon)
gas discharge headlight lamps (for ver-
sions/markets, where provided), it is nor-
mal that there should be a vertical move-
ment of reflectors, and consequently the
F0S056Ab
same will also happen to the light beam,
for the time required to achieve the cor-
rect headlight trim stabilisation, equal to
approx. 2 seconds.
51