Connections - Aiwa XD-DV480 Operating Instructions Manual

CONNECTIONS

Before connecting, identify your type of audio equipment or TV referring to the following chart. Then, decide the connection
and the setup procedure accordingly.
NOTES
• The unit cannot be connected to a TV which is not equipped with a video input connector.
• Use a commercially available stereo-monaural audio cord when connecting to a monaural TV.
Audio system to be connected
None (only a TV is connected)
A stereo system or an amplifier
An AV receiver equipped with Dolby Digital
decoder or a Dolby Digital decoder
An AV receiver equipped with DTS decoder
or a DTS decoder
Before making connections
• Connect the AC cords of the unit and any external
equipment last, after finishing all other connections.
• Insert the plugs completely into the jacks. Loose
connections may produce a humming sound or other
noise interference.
• When using an optical connection, remove the dust cap
from the DIGITAL OUT (OPTICAL) jack on the rear of
the unit. Keep the cap handy. When not using optical
connections, the dust cap should be replaced.
• Refer to the instructions of the connected equipment.
NOTE
• If picture noise appears while playing copy-protected
DVDs, connect the unit directly to a TV. Do not connect
through a VCR, TV/VCR, or AV selector.
• For speaker connection, refer to the instructions of the
AV receiver.
CAUTION
Do not select "DOLBY DIGITAL/PCM" or "Stream/PCM"
in the "Digital Audio Output" of the setup menu when
connecting to an AV receiver not equipped with a Dolby
Digital decoder or DTS decoder (with an optical or coaxial
connecting cord).
Merely attempting to play a DVD may cause a screeching
noise which could be harmful to your ears and damage
the speakers. In such a case, be sure to select "PCM" in
the "Digital Audio Output".
Input jack of equipment to be
connected to the unit
Digital input jack
Analogue audio input jacks (L/R)
Digital input jack
Analogue audio input jacks (L/R)
Digital input jack
TV SYSTEM SELECT switch
This switch enables you to make use of a TV which is NTSC
or Multi colour system. The default setting is "PAL".
Before turning on the unit;
• Set to "PAL", when connecting to the TV of PAL colour
system.
• Set to "AUTO", when connecting to the TV of Multi colour
system.
• Set to "NTSC", when connecting to the TV of NTSC colour
system.
PAL AUTO
NTSC
PAL AUTO
NTSC
NOTE
The unit cannot playback DVDs and video CDs that are
recorded in the PAL colour system, if "NTSC" is set.
VIDEO OUTPUT switch
• Switch to "SCART" when connecting to the TV with the
21pin scart cable.
• Switch to "S-VIDEO" when connecting to the TV with the
S-video cord.
Connection
type
A on page 10
B on page 11
C on page 12
D on page 13
F on page 15
E on page 14
DIGITAL AUDIO
OUT OUT
COAXIAL
L
DIGITAL
OUT
S-VIDEO
R
SCART
VIDEO S-VIDEO VIDEO
OPTICAL
OUTPUT OUT
OUT
S-VIDEO
SCART
CONTINUE
En
9
ENGLISH