Troubleshooting; Assistance Or Service; Replacement Parts - Whirlpool furnace User Instructions

First try the solutions suggested here and possibly avoid the cost of a service call.
Unit fails to operate
Check the following:
Is the main switch that supplies power to the unit in the ON
position?
Is the manual gas control valve in the OPEN position?
Has a fuse blown, or has the circuit breaker tripped? If
problem continues, call an electrician.
Is the thermostat set properly? See "Adjusting the Controls."
If you need further assistance, you can write to the below
address with any questions or concerns:
Whirlpool ® Home Cooling and Heating
14610 Breakers Drive
Jacksonville, FL 32258
Please include a daytime phone number in your correspondence.

Replacement Parts

To order replacement parts contact your Whirlpool
Cooling and Heating dealer.
Gas Control Group
Manifold
Burner
Orifice
Flame sensor
8

TROUBLESHOOTING

ASSISTANCE OR SERVICE

® Home
Gas control valve
Hot surface igniter
Ignition control
Unit is operating but not providing complete comfort
Check the following:
Is the thermostat set properly? See "Thermostat Control."
Is the filter clean? Replace or clean filter. See the "Filter
Maintenance" section.
Is the air able to circulate freely throughout your home? Do
not block supply registers or return grilles with furniture
or rugs.
Heat Exchanger Group
Primary heat exchanger
Secondary heat exchanger (if used)
Condensate drain pan (if used)
Blower Group
Blower housing assembly
Blower wheel
Blower motor
Inducer Group
Pressure switch
Electrical Group
Limit control
Transformer
Rollout switch
Blower motor mount
Capacitor
Inducer blower
Auxiliary limit (if used)
Blower door interlock
switch