IFM Electronic E2D400 Series User Manual page 56

E2D400 Series Panel PC
NOTE:
When purchasing the cabinet/rack installation bracket, make sure it is
compatible with both the E2D400 series flat panel PC and the rack/cabinet
into which the E2D400 series is installed.
Step 1: Slide the rear chassis of the E2D400 series flat panel PC through the
rack/cabinet bracket until the aluminum frame is flush against the front of the
bracket (Figure 4-17).
Figure 4-17: The Rack/Cabinet Bracket
Step 2: Insert the rack mounting clamps into the pre-formed holes along the edges of
the flat panel PC, behind the ABS/PC plastic frame. There are a total of 6 rack
mounting clamps for E2D400.
Step 3: Tighten the screws that pass through the rack mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the bracket (Figure 4-18).
Page 46