Download Print this page

IMPRESSA J5 Quick Reference Manual

Impressa j5

Advertisement

Quick Links

J5 Quick Ref 5-15-07
5/15/07
12:29 PM
can continue to make coffee, however we highly recom-
mend cleaning the machine as described below within the
next few days. To re-order tablets see chapter 15 below.
Important: Once the cleaning program has started do not
interrupt the procedure.
CLEAN / READY
1. Push Rinse Button. The display shows
Attention: If the tray and the used coffee container are
already empty, you still need to remove the tray for
approx. 20 seconds and then replace it.
2. Make sure that the water container is at least half full.
Remove and empty the tray and the used coffee container
and replace. The display shows
PRESS RINSE
rinse button is illuminated.
3. Place a container (at least 20 oz.) underneath the coffee
spouts and push the Rinse Button.
4. The display shows CLEANING. The machine pumps
one or two short cycles of water through the coffee
spout. Then the display shows
ADD
5. Open the ground coffee funnel lid
and drop one white tablet into the
opening. Close the lid. The display
shows
PRESS
RINSE.
6. Push the Rinse Button again, and
the cleaning program continues.
The display shows CLEANING.
The machine starts the automatic
cleaning program by dispensing
water in intervals into the container underneath the coffee
spout. The program stops automatically and the display
shows
EMPTY
TRAY.
7. Remove the container and then the drawer and tray.
8. Empty drawer and ground coffee container and replace.
9. The display shows READY.
The machine will automatically remind you after the next
200 cups of coffee to repeat this cycle.
14. DECALCIFYING /
DE-SCALE READY
The machine has an integrated decalcifying program. This
program takes about 40 minutes. When the display shows
DE-SCALE / READY
it is time to decalcify the machine.
The Rinse button is illuminated. You can still make coffee.
However, it is highly recommended decalcifying the
machine within the next 3 to 4 days.
Important CLEARYL FILTER: If you use the Clearyl
water cartridge and the display shows
READY, then your cartridge function was not activated.
Follow the instructions in chapter 11 above.
Important: Do not interrupt the decalcifying program.
DECALCIFYING AGENT: Only use our special decalcifying
tablets Model #61848, see chapter 15 below.
Page 1
CAUTION: Never use vinegar or any other decalcifying
agent. This might damage internal parts of the machine.
CAUTION: Immediately remove any splashes or drops of
the decalcifying solution from sensitive surfaces, such as
natural stone or wood. Always wait until the decalcifying
solution in the water tank has been used up. Do not fill
EMPTY TRAY
additional decalcifying solution into the water tank.
DE-SCALE READY
1. Push the Rinse Button, display shows
Attention: If the tray and the used coffee container are
already empty, you still need to remove the tray for approx.
20 seconds and then replace it.
and the
2. Empty the Water Tank. The Clearyl filter should not be
in the water tank.
3. Remove the frothXpress or the Dual Frother Plus.
4. Dissolve 3 of the large square decalcifying tablets in a
container with 20 oz. of water (0.6 liters) and pour the
solution into the water tank.
TABLET.
5. Replace water tank.
6. Place a container (at least 20 oz.) under the steam nozzle.
7. Push the Rinse Button. The display shows DE-SCALING.
During this operation, the Rinse button blinks.
8. After approx. 15 minutes the action stops and the display
shows
EMPTY
9. Remove the container and then the drawer and tray.
10. Empty the drawer and the ground coffee container.
Then replace.
11. Remove the water tank, rinse and fill with up to 18 oz.
of fresh cold water and replace.
12. Place the container under the steam nozzle and press the
Rinse Button.
13. The J5 pumps the fresh water through the system.
During this operation, the Rinse button blinks.
14. When the display shows
container and then the drawer and tray.
15. Empty the drawer and the ground coffee container.
16. Replace the Dual Frother Plus or the frothXpress.
HEATING. READY.
The machine is ready to make coffee again.
The machine will automatically remind you when it's time to
decalcify again.
15) SUPPLIES can be ordered through:
Customer Service, Mail Order Form or www.capresso.com
• Clearyl Water Filter Cartridge: #64553
DE-SCALE /
• Cleaning Tablets: #62205
• Decalcifying Tablets: #61848
CAPRESSO CUSTOMER SERVICE: 1-800-220-5701
M-F 9AM - 9PM; Sat. 9AM - 5PM EST
FAX: 201-767-9684; email: contact@capresso.com
67134
and the Rinse button is illuminated.
EMPTY
TRAY.
AGENT IN
TANK.
TRAY.
FILL WATER
TANK.
PRESS
RINSE.
EMPTY
TRAY, remove the
Impressa J5 Quick Reference Guide
This Guide does not replace the Operating Instructions.
For details and cautions you must read all instructions.
We highly recommend watching the instructional video.
Traces of Coffee Grounds in New Machine?
This is normal! Grinder was tested during assembly with beans.
Despite cleaning, traces of ground coffee may be found.
RED TEXT
represents display text.
On/Off
Rotary
Push
Rinse
Button
Dial
Button
Button
Important: You can only brew coffee when display shows
READY.
Important: You can always stop the flow of coffee, hot water
or steam by pushing any of the beverage buttons or the button
in the Rotary Dial.
1) FIRST TIME EVER PREPARATION
Do not install CLEARYL Filter Cartridge now.
1. Place machine on a flat water/steam/heat-resistant surface.
Move the dual coffee spouts up and down and in and out.
2. Plug in machine and turn the Main Power Switch on
(right side of machine next to the power cord). The On/Off
button on top of the machine illuminates.
3. Push the On/Off Button on top of machine to turn the
machine on. The LED display turns on.
4.
FILL WATER
TANK. Remove water tank (left side) and fill
with fresh water.
5.
PRESS
RINSE. Place a cup under the frother and push
the Rinse Button.
SYSTEM
FILLING.
6. HEATING. Then
PRESS
RINSE.
Place a cup under the coffee spouts
and push the Rinse Button.
7.
FILL
BEANS. Fill beans into the
bean container. READY.
8. Place a large cup underneath the
coffee spouts and push the
2-Cup Espresso Button. If the
machine still says
FILL
BEANS,
push the 2-Cup Espresso Button
again.
9. Discard the first two cups of coffee.
READY
Bean Container Lid
Bean Aroma Lid
Beverage Buttons
1 Espresso
2 Espressi
Hot
Steam
Water
®
CAPRESSO
1 Coffee
2 Coffees

Advertisement

loading

Summary of Contents for IMPRESSA J5

  • Page 1 7. Remove the container and then the drawer and tray. 2. Plug in machine and turn the Main Power Switch on 13. The J5 pumps the fresh water through the system. 8. Empty drawer and ground coffee container and replace.
  • Page 2 12. Fill water tank with fresh cold water and replace. frothXpress (attached) and Dual Frother Plus (in storage • Place a cup with cold water next to the J5 and insert the 13. Place a 20 oz. container under the steam nozzle.