Assigning Names To The Sources - JVC KD-LH3100 Instructions Manual

Assigning names to the sources

You can assign names to station frequencies,
CDs (both in this unit and in the CD changer),
and the external component.
After assigning a name, it will appears on the
display when you select the source.
Sources
Station frequencies
CDs*
External component Up to 8 characters
* You cannot assign a name to a CD Text or an MP3
disc.
1
Select a source you want to assign a
name to.
(For KD-LH3150)
When you select a source, the power
automatically comes on.
2
While pressing D (DISP), press and
hold SEL (select) for more than
2 seconds.
The next-step-operation buttons start
flashing.
Ex.: When you select CD as the source
46
Maximum number of
characters
Up to 10 characters (up to
30 station frequencies
including both FM and AM)
Up to 32 characters (up to
40 discs)
(For KD-LH3100)
3
Select the character set you want
while the first character position is
flashing.
Each time you press the
button, the character set
changes as follows:
(A – Z: capital)
(0 – 9: numbers, and
4
Select a character.
5
Move the cursor to the next
(or previous) character position.
6
Repeat steps 3 to 5 until you finish
entering the name.
7
Finish the procedure while the last
selected character is flashing.
To erase the entered characters
Insert spaces using the same procedure
described above.
Notes:
• When you try to assign a name to the 41st disc or to
the 31st station frequency, "Name Full" appears
and you cannot enter the text entry mode. In this
case, delete unwanted names before assignment.
• When the CD changer is connected, you can assign
names to CDs in the CD changer. These names can
also be shown on the display if you insert the CDs
in this unit.
(a – z: small)
symbols)
• About the available
characters, see page
56.