Attaching The Band Saw Trak - Kreg KMS7200 Instruction Manual

7
Assembly Instructions
Figure 3 Figure 3
Black T-Knob
Clamp Block

Attaching the Band Saw Trak

Refer to Fig. 3
The Trak attaches to the Clamp Block via the Adapter Bracket.
These parts are designed in such a way that the fence may be
used on either side of the blade. In addition to this feature the
Trak may be positioned anywhere along the Adapter Bracket. By
loosening the anchoring bolts and simply sliding the Trak along the
face of the Adapter Bracket the Trak can be positioned forward for
situations where additional support is required in front of the blade.
This unique mounting system will also allow the user to rotate the
Trak 90° to create a Low Profi le fence. Maximum guide support
is maintained while making narrow cuts where the fence would
normally interfere with the guide system.
1. Insert the head of each of the 1/4-20 x 2-1/2" bolts into the
single groove of the inside face of the Band Saw Trak.
2. Align these bolts to fi t into the openings of the Adapter
Bracket uprights. Lower the Trak along the face of the
Adapter Bracket until the Trak is supported by the band
saw table surface and the Adapter Bracket.
3. Place a 1/4" Brass Washer on each bolt and follow with the
Black T-Knob. A rigid connection between the Clamp Block and
the Trak is formed after tightening the Black T-Knobs.
4. Test the operation of the Band Saw Fence by sliding it back
and forth along the Mounting Rail.
Tip
An effortless movement of the fence to the left and right can be
obtained by tightening the Lock Down Knob to "pull" the fence
square with the double-dovetail locking mechanism then
backing-off the Lock Down Knob ever-so-slightly. Experiment
with the position of the Lock Down Knob to attain the
smoothness you desire when positioning the fence
Adapter
1/4" Brass Washer
Bracket
Lock Down Knob
Regular cutting position
Low profi le position of fence allows blade guard to
be lowered
1/4"x2-1/2"
Hex Bolts
Band Saw Trak