Two Car Operation; Advanced Commands: Function Level - Python 1401 Owner's Manual

2. Turn both the unit
front and circuit board
over, remove battery
from clip and replace.
Note:
Verify that the bat-
tery polarity is correct
when replacing.
3. Reposition all parts and snap together.
>
Two car operation
You can use the remote control system for two cars, with full command capabil-
ity for both vehicles.
To change the car selection:
• Press and hold the
f
button for 3 seconds until the amber LED blinks
once or twice indicating the current vehicle:
One blink: Car
1
Two blinks: Car 2
• To scroll from one car to the other, press the
f
button again. Aher select-
ing the car, operation resumes. The selected car remains selected until the
setting is changed.
Note: Car 2 mode must be programmed On. See
Configuring your remote.
©
2009 Directed Electronics. All rights reserved.
3