Setting Up The Device; E911 Information - Sprint Phone User Manual

Setting Up The Device

1.
Connect the antenna by screwing it into the
connector on the back of the device.
2.
Connect a wired or cordless telephone to the
device using the supplied RJ-11 phone cord.
3. Plug the power adapter cable into the device.
4.
Plug the power adapter into a wall outlet.
4 1A. Basic Installation
Note:
Use only wired or cordless telephones that conform
to FCC part 68 requirements. Noncompliant
telephones may not work properly.
WARNING:
Do not connect this device to your telephone
wall outlet. This configuration is not supported
unless you have taken steps to disconnect
existing landline wiring coming into your
home or office.

E911 Information

Your device features an embedded Global Positioning
System (GPS) chip necessary for utilizing E911
emergency location services where available. During
the emergency call, all the LEDs on the terminal will
blink and your location can then be determined by the
911 operator.
Important:
Always report your location to the 911 operator
when placing an emergency call. Some
designated emergency call takers, known as
Public Safety Answering Points (PSAPs) may
not be equipped to receive GPS location
information from your device.