Accuphase E-213 Instruction Manual page 13

n n n n n Connect the output cable from the analog record player correctly to
the input jacks on the board. Also connect the ground cable from the
analog record player to the ground (GND) terminal on the board.
Playback
a Verify that the VOLUME control is turned fully down, and then turn power to
the E-213 and the other components on. Select the OPTION position of the
input selector. (This position is for the slot where the AD-9 or AD-10 is
installed.)
b Lower the stylus onto the record and adjust the volume to a suitable level.
c If the record is notably warped or if there are excessive woofer excursions
caused by turntable rumble, enabling the subsonic filter can help to reduce
noise.
Analog Disc Input Board AD-9
This board serves for playback of analog records. It contains a
high-performance, high-gain phono equalizer. The board can be
used with any type of phono cartridge.
m By installing two of these boards, two different phono cartridges
can be connected at the same time.
LEFT, RIGHT analog record player input jacks
Connect the output cable from the analog record player to these
jacks.
GND terminal
Connect the ground cable from the analog record player to this
terminal.
Before inserting the board, the DIP switches must be set
to the required positions.
OTHER OPTION BOARD
Line Input Board LINE-9
This option board provides an additional set of analog line
inputs that are similar to the INPUTS of the E-213. They can
be used to connect a CD player, tuner, or other component
with analog output.
OPTION BOARD INSTALLATION
A Set the power switch of the E-213 to OFF.
B On the rear panel, remove the panel covering the option slot.
C Insert the option board by sliding it into the top and bottom guide rails of
the option board slot. When the board touches the internal connector,
give it a slight push until the board is firmly seated. (The board must be
flush with the panel.)
D Secure the board with the two screws at the top and bottom.
RCAUTION
m Be sure to turn the E-213 OFF before inserting or removing any
option board. Otherwise damage to the board or to the amplifier can
occur.
m Take care not to touch the components, the printed circuit side, or
the connector edge of the board, to prevent possible contact problems
or damage. Hold the board only by the edges or the rear panel.
m Be sure to securely fasten the board with the two screws. Otherwise
insufficient grounding may lead to function problems and damage.
Guide rail
Sub-
panel
Guide rail
Option
board
✽ The illustration shows the
DAC-10.
11