Introduction, General Information, Serial Number - Horst Welding CHCF25 Operator's Manual

INTRODUCTION
Thank you for purchasing your new Horst Contour 4 Wheel Steer Header Wagon. Your Contour Header Wagon
has been designed and manufactured to give you many years of dependable service. You or any other person, who
will be assembling, operating, maintaining or working with this product, are required to read and completely
understand the information and instructions contained in this manual. If anyone does not fully understand every part
of this manual, please obtain further assistance by contacting the dealer from which this product was purchased or
by contacting Horst Welding at the telephone number or address listed on the previous page of this manual. Keep
this manual available for reference whenever this product is being handled or used. Provide this manual to any new
owners and/or operators.
This manual covers models: CHCF25, CHCF30, CHCF36, CHCF42
CHCFD36, CHCFD42
GENERAL INFORMATION
The purpose of this manual is to assist you in safely operating and maintaining your Contour Header Wagon in a
safe manner. Read this manual carefully to obtain valuable information and instructions that will help you achieve
safe and dependable service. The illustrations and data used in this manual were current at the time of printing, but
due to possible engineering and/or production changes, this product may vary slightly in detail. Horst Welding
reserves the right to redesign and/or change components as necessary without notification.
SERIAL NUMBER LOCATION
The serial number for your Contour Header Wagon is located on the back top right side of the rear axle.
- 2 -