Introduction ............................5 For the Record ..........................5 Included With Your Distiller ....................5 Optional Accessories ........................5 Getting to Know the Fountain Classic ................6 Installation ............................8 Maintenance ............................ 11 Post Filter Changing and Steam Sterilization ..........11 Cleaning the Boiling Chamber .................
If the unit was placed on its side for transport, be sure to allow the unit to stand upright for at least four hours before plugging unit in. • Do not locate the unit in an area where the temperature falls below freezing. Page 4 Fountain Classic Owner’s Manual...
Introduction Congratulations on purchasing the finest water distillation system on the market. With proper care and attention, the Fountain Classic will give many years of top performance and high-quality drinking water. Please read this manual thoroughly before installing and operating your Fountain Classic.
Photo Display—This is a backlit area to display photos or advertising. Several Photo Display Photo Display Photo Display optional displays are available from Pure Water, Inc. or from your local dis- tributor. Water Dispensing Area Water Dispensing Area—Three temperature units have dispensers for Hot...
Page 7
Plug Adapter—This plug provides power for the entire unit through the power cord. Emergency Overflow Float Emergency Overflow Float Emergency Overflow Float Emergency Overflow Float Emergency Overflow Float—Turns the unit off automatically if water fills the bottom pan. Fountain Classic Owner’s Manual Page 7...
NOTE: : : : : Do not plug the unit into the power source until instructed to do so. The installation of the Fountain Classic is very simple. The steps are as follows: 1. Position the unit in a well ventilated area.
Page 9
3. Place the 2 bulbs into their sockets. Turn into place. 4. Place transparency behind the transparency cover and lower into place. 5. Replace the top panel and screw into place. Now you can turn the light switch ON. Fountain Classic Owner’s Manual Page 9...
Page 10
Allow the distiller to operate for an additional 5-6 hours. Several gallons of water will be in the storage tank. It is now safe to turn the Cooler Power switch to ON, and the Dispenser Hot Water Switch to ON. (Three temperature unit only.) Page 10 Fountain Classic Owner’s Manual...
3. Allow the unit to distill for 5-6 hours. 4. Using the spigots in the front, empty the water from the unit. This water should be dis- carded. Fountain Classic Owner’s Manual Page 11...
11. Allow the lumen to soften any scale (allow 12-24 hours for scale to soften). 12. Drain and rinse boiling chamber. 13. Reconnect tubing and electrical connections. 14. Turn the distiller switch to the ON position. Page 12 Fountain Classic Owner’s Manual...
No hot water from is full. dispenser. (Three temperature Hot temperature control. Adjust or Replace. unit only. Leaking of any kind. Various. Disconnect power and shut off the feed water supply. Call for immediate service. Fountain Classic Owner’s Manual Page 13...
Need help?
Do you have a question about the Fountain Classic and is the answer not in the manual?
Questions and answers