1. Manuals
  2. Brands
  3. Pure Water Manuals
  4. Water Dispenser
  5. 200 Series
  6. Owner's manual

Pure Water 200 Series Owner's Manual

Hide thumbs
1
2
3
4
5
6
7

Advertisement

Table of Contents

Water Dispenser Owner's
Manual – 200 Series
IMPORTANT: This manual includes important safety material; please read all
instructions before plugging power supply cord into receptacle.
®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 200 Series and is the answer not in the manual?

Questions and answers

Related Manuals for Pure Water 200 Series

Summary of Contents for Pure Water 200 Series

  • Page 1 ® Water Dispenser Owner’s Manual – 200 Series IMPORTANT: This manual includes important safety material; please read all instructions before plugging power supply cord into receptacle.
  • Page 2 Load water bottle FIRST. STOP & READ DIRECTIONS STOP before plugging in dispenser. Dispense water from hot and cold faucets. Read complete HOW TO INSTALL instruction sequence before plugging in and turning on dispenser. Failure to follow proper installation instructions may cause damage THEN turn on the hot tank switch.
  • Page 3 CHILD SAFETY CAUTION: Supervise children when using the dispenser. The hot dispenser faucet is equipped with a child safeguard that reduces the risk of hot water being dispensed accidentally or by small children. To dispense hot water, simultaneously depress the child safety lock (located above the left hot faucet handle) and the left hot faucet handle.
  • Page 4 10. Place a cup under the dispenser faucet. To dispense hot water, depress the child safety lock (located above the left hot faucet handle) and the left hot faucet handle simultaneously until water flows continuously. Next, depress the right cold water faucet handle to make sure there is a continuous flow of water.
  • Page 5 Clean the drip tray and grill by emptying the tray and cleaning the tray and grill with dishwashing soap or by placing them on the top rack of the dishwasher (Fig 2). TIP: The drip tray and grill should be cleaned monthly. Fig 2 Press the cover lock on the top rim of the cooler and pull up to open (Fig 3).
  • Page 6 10. Replace the separator and close the cover (Fig 7). Wipe down the cooler and the surrounding area to dry any water spills. 11. Wash your hands thoroughly with soap and water for at least 20 seconds. Install a full water bottle on the dispenser. Dispense water through the hot and cold spigots. Turn on the hot tank heater switch located at the rear of the dispenser.
  • Page 7 DISPENSER IS NOISY • Make sure the dispenser is on a level floor or counter strong enough to support it when fully loaded. • It is normal for the bottle to make a gurgling noise as water fills the tank. •...

Table of Contents