First-Time Setup - Bang & Olufsen BeoVision?10-32 Manual

The setup procedure is activated
when the television is connected
to the mains and switched on for
the first time. You are led
through an automatic series of
on-screen menus in which you
must set up the TV and register
the extra equipment you have
connected, such as loud s peakers.
If you change your setup at a later
date, you can access the same
menus and update your settings.

First-time setup

The sequence of menus in first-time setup
MENU LANGUAGE ... You can select the
language for on-screen menus. The text
on the screen changes as you move from
language to language.
STAND ADJUSTMENT ... Set the maximum
angle for turn of the television. Use and
to turn the television and limit the
movement of the stand.
STAND POSITIONS ... Set your preferred
preset positions for the television. For
further information about the STAND
POSITIONS menu, see page 7.
TUNER SETUP ... Disable the television tuner
or DVB tuner, if you like, see page 8.
STANDBY SETTINGS ... The television can be
set to switch itself to standby after some
time with no operation. You can also switch
Power Saving on or off, see page 26.
CONNECTIONS ... Select the type of
equipment you have connected to each
socket group, the sockets used, the
product name, and the source name. For
further information about the
CONNECTIONS menu, see page 9.
CHECK AERIAL CONNECTION ... This
prompt only appears, if the television
tuner is enabled.
AUTO TUNING ... When you have registered
your connected equipment, a menu for
channel tuning automatically appears on
the screen. Use the navigation button
right to start auto tuning. The television
finds all available channels. For further
information about tuning TV channels,
see page 16.
5
SPEAKER TYPE ... Select which speakers are
connected to the television, if any. See
page 20, for further information.
ADJUSTMENT ... Adjust bass, balance,
volume, treble, etc.
DVB SETUP ... If the DVB tuner is enabled,
the DVB SETUP menu appears, see the
separate DVB Guide for further
information.
For information about where to connect
extra equipment, see the chapter about
connection panels in Getting Started.