Advertisement
All installations and services must be performed by qualified service personnel.
H. HEAT EXCHANGER CLEANING INSTRUCTIONS:
c WARNING: THE HEAT EXCHANGER MUST BE CLEANED BY A QUALIFIED
SERVICE PERSON.
It is important to inspect and clean the heat exchanger once a year, or as necessary, to remove any build-up of soot.
A layer of soot on the inside of the heat exchanger will act as an insulator and reduce heat transfer, resulting in less
efficiency.
To clean the heat exchanger, first turn off all power to the unit. Remove clean-out plugs, the vent connector pipe to
the chimney, the burner, and the burner mounting plates. When removing the clean-out plugs, remove the screw at
the 12 o'clock position. Then, pull clean-out plug straight back.
Fig. 6: Clean-out plug removal
With access to the inside of the heat exchanger through the burner area, clean-out openings, and vent pipe
connection, it is possible to use a long, flexible wire brush and an industrial type vacuum cleaner to remove any soot
build-up. NOTE: A one inch (outside diameter) vacuum cleaner hose will fit into the radiator.
To vacuum and brush the outer radiator of the heat exchanger, go through the clean-out openings in both directions,
as shown in figure 7, below.
Fig. 7: Recommended method and device for cleaning inside of heat exchanger.
Reassemble the furnace to its original construction*. Remount the burner being certain that the air tube is properly
inserted into the chamber opening (see section F). If heavy soot deposits were found in the heat exchanger, this may
indicate the burner is out of adjustment.
*When returning clean-out plugs to their original position, insert plug and replace screw at the 12 o'clock position.
This is sufficient for sealing the access tube.
8
Hide quick links:
Advertisement
