Bushnell 119437 Instruction Manual page 34

2. Check the batteries to make sure that they are new alkaline or lithium
3. Make sure that the camera power switch is in the "On" position and
4. Make sure that you are using a good quality SD card in your camera.
5. If the SD card has its write protect switch in the lock position, the
6. If you have used an SD card in another device before inserting it in
Camera won't power up
1. Make sure that you have installed at least 4 batteries (the required
2. Make sure that the batteries are installed correctly, observing proper
3. After moving the switch from "Off" to "Setup" or "On", make sure
4. Do not move the switch directly from "On" to "Setup"-always move
Still Photo and/or Video Quality Problems
1. Night photos or videos appear too dark
34
2012 TrophyCams 1280HD_119437C+119447C+119476C+119477C_2LIM for Canada_040412.indd 34
AA batteries. See note above about short battery life.
not in the "Off" or "Setup" modes.
Bushnell recommends SanDisk ® SD Cards up to 32GB (Ultra
Extreme series for HD video) .
®
camera will not take images.
your Trophy Cam, you might want to try formatting the card using the
"Format" parameter in Setup mode (make sure you have backed up any
important files first, as formatting will erase all previous files). In some
cases, other devices may change the formatting of the SD card so that
it will not work properly with the Trophy Cam.
minimum #) in the battery compartment, starting at the top, filling
battery spaces 1-4 with no "gaps".
Bushnell recommends using a full set of 8 or 12 Energizer ®
Lithium AA batteries in your Trophy Cam (the max. capacity for
your model).
polarity. Always place the negative (flat) end of each battery in contact
with the spring side of its slot inside the camera.
that the switch is correctly in position to ensure the proper mode (avoid
positions "between" two modes).
the switch all the way down to "Off" first, then back up to "Setup".
a. Check the battery indicator icon to see if battery power is full. The
flash will stop operating near the end of the battery life.
b. You will get the best results when the subject is within the ideal
flash range, no farther than 45' (14m) from the camera (or 60' (19m)
for models 119437/119447). Subjects may appear too dark at greater
distances.
or
®
4/4/12 1:52 PM