Set-Up Menu Items - JVC TM-15L1D Instructions Manual

How to Use the SET-UP MENU
7

SET-UP MENU items

PICTURE SUB ADJ.
Sets the standard level for the picture adjustments by using the CHROMA/PHASE and CONTRAST/BRIGHT buttons
on the front panel.
CONTRAST* Adjusts the standard level for contrast adjustment.
BRIGHT* Adjusts the standard level for brightness adjustment.
CHROMA* Adjusts the standard level for chroma adjustment.
PHASE* Adjusts the standard level for phase adjustment.
reset Restores the items in "PICTURE SUB ADJ." to the factory settings.
* Memorized for each input.
COLOR TEMP.
Selects the color temperature and adjusts the drive level of each color (R/G/B).
COLOR TEMP.* Selects the color temperature.
• When selecting "USER1" or "USER2," adjust the R/G/B
R DRIVE Adjusts the drive level of red.
G DRIVE Adjusts the drive level of green.
B DRIVE Adjusts the drive level of blue.
* Memorized for each input.
SIZE/POSI. ADJ. (USER)
Adjusts the position and size of the picture. This item is available only when "SCAN SIZE" (☞ page 8) is set to
"USER."
H. SIZE* Adjusts the horizontal picture size.
H. POSI.* Adjusts the horizontal picture position.
V. SIZE (4:3)* Adjusts the vertical picture size (for 4:3 aspect ratio).
V. SIZE (16:9)* Adjusts the vertical picture size (for 16:9 aspect ratio).
V. POSI. (4:3)* Adjusts the vertical picture position (for 4:3 aspect ratio).
V. POSI. (16:9)* Adjusts the vertical picture position (for 16:9 aspect ratio).
* Memorized for each input.
REMOTE SETTING
Sets the MAKE/TRIGGER terminal. (☞ page 18)
SYSTEM Selects the external control system of the MAKE/TRIGGER
terminal.
PORT F3 Selects the input which is controlled by the 3rd pin terminal
of the MAKE/TRIGGER terminal.
PORT F4 Selects the input which is controlled by the 4th pin terminal
of the MAKE/TRIGGER terminal.
16
drive level below.
(cont.)
–20 - 00 - +20
–20 - 00 - +20
–20 - 00 - +20
–20 - 00 - +20
HIGH (9300), LOW (6500),
USER1, USER2
–40 - 00 - +40
–40 - 00 - +40
–40 - 00 - +40
–40 - 00 - +40
–40 - 00 - +40
–40 - 00 - +40
–40 - 00 - +40
–40 - 00 - +40
–40 - 00 - +40
MAKE (make contact
system), TRIG. (trigger
system)
VIDEO 1, VIDEO 2, COMPO.,
SDI 1, SDI 2
• You cannot assign the same
input to both "PORT F3" and
"PORT F4."