LG MFL40910613 Installation Manual page 14

Remote controller installation
Installation of Wired remote controller(Cassette type)
1. Connect the wired remote controller cable
to the wired remote controller installation
board as shown in the right picture.
12V Red wire
SIG Yellow wire
GND Black wire
The wired remote controller cable is connected as factory default.
2. After fixing the cable to the guide slot,
attach the wired remote controller
installation board at the desired location.
• Before fixing the wired remote controller cable
to the guide slot, remove any clogged part of
the case in the direction to install before the
installation.
3. After locating the wired remote
controller installation board at the
desired location, screw the unit firmly.
(When there is a buried box, install the
wired remote controller board to fit the
buried box.)
• Use the screw provided.
4. After fixing the top part of the wired
remote controller to the installation
board as shown in beside picture, press
the bottom part to assemble the
controller to it's board.
When disassemble the wired remote controller
from the installation board, use the driver as
shown in the right picture and insert it into the
hole with the arrow. And when you pull the driver
in the front direction, the wired remote controller
will be separated.
14 Air Conditioner
12V SIG GND
Red
Yellow
Black
<Front side of
installation board>
Top
Fixate the remote
controller cable
to the guide slot.
Use the screws
for fixate the unit
firmly on the wall.
Installation board
Bottom
Wall
Side
Wall
Side
Remote Controller
Cable
Guide slot
<Rear side of
installation board>
Wall
Side
Wall
Side
Wall
Side