Water Tank Filter (Models Dfw/Dfwt-100/150 Only); Checking And Cleaning The Water Strainer (Monthly) Dfw/Dfwt/Dfwf-200/250 Only - Antunes, AJ Series 9100100 Owner's Manual

NOTE: Failure to properly clean and dry the above
mentioned items may result in the accumulation
of water/moisture overnight. This may lead to per-
manent damage to the equipment's finish and its
accessories. This damage is not covered by war-
ranty.
Water Tank Filter (Models DFW/DFWT-100/
150 Only)
The Water Tank Filter is used to prevent particles or
food products from entering and damaging the water
pump. The unit uses a water filter (Figure 12). Inspect
and clean this filter monthly or more regularly using the
following procedure.
1. Turn the Rocker Switch (power On/Off) to OFF.
Unplug the power cord and allow the unit to cool
down before proceeding.
2. Open the Slide Door (Figure 11).
3. Remove the Filter, located inside the tank, by pull-
ing it upwards and out of the bottom hole.
Slide Door
Bottom
Hole
of Water
Tank
Figure 11. Water Tank Filter
Tubing
NOTE: If the Male Quick Disconnect Fitting leaks water while
it is engaged into the rear of the Steamer, then the O-ring
must be replaced. Three (3) spare O-Rings are supplied.
P/N 1010678 Rev. F 09/04
MAINTENANCE (continued)
Checking and Cleaning the Water Strainer
(Monthly) DFW/DFWT/DFWF-200/250 Only
The Water Strainer protects your equipment from any
foreign debris in the water line that could damage the
unit's solenoid (causing the unit to leak/flood)
To ensure proper and consistent steaming results, visu-
ally check the Water Pressure Regulator Gauge (figure
12) and Strainer Cup regularly. If the pressure on the
Gauge has dropped, visually check the clear, plastic
Strainer Cup and clean out the accumulated debris as
follows:
Water Tank Filter
Filter Stem
Access
Cover
with Tank
(dotted line)
O-ring
Strainer Cup
Figure 12. Inlet Hose Assembly
17
DELUXE FOOD WARMER
4. Clean the Filter by running it under tap water.
Replace the Filter if the screen is torn or dam-
aged.
5. Reinstall the filter stem into the bottom hole of the
tank (Figure 11).
6. Fill the Water Tank and test the unit.
1. Shut off the water supply valve to the unit,
unscrew the clear, plastic Strainer Cup, and care-
fully remove the mesh Strainer Screen.
2. At the sink, gently flush all of the accumulated
debris from the Strainer Cup and mesh Strainer
Screen. Be especially careful not to damage the
mesh Strainer Screen.
3. Carefully place the mesh Strainer Screen into its
seat at the bottom of the clear, plastic Strainer
Cup and confirm that the orange O-ring is proper-
ly seated in its place before screwing the Strainer
Cup and top back together.
4. Purge the air out of the Strainer and tubing by
disconnecting the male quick disconnect insert
from the equipment and, over a bucket, push the
"white" plastic tip in until there is good water flow.
Mesh
Screen
Spare O
Rings (3)
O Ring
Male Quick
Disconnect
Insert