Antunes, AJ Series 9100100 Owner's Manual page 13

7. Press and release the Program button again and
use the UP or DOWN arrow buttons to change the
SHO setting in minutes (Item F, Figure 7).
NOTE: 00 minutes is recommended.
8. Press and release the Program button again and
H2O is displayed (Item G, Figure 7).
9. To change the H2O setting, press and release the
Program button again to display the setting (Item
H, Figure 7). Use the UP or DOWN arrow buttons
to increase or decrease the time.
NOTE: Recommended settings are :
• DFW/DFWT/DFWF-250 [0_50]
• DFW/DFWT-150 [0_08]
READY
1500
UP DOWN PROGRAM START/STOP
POWER
A. Total Cycle Time
READY
20
UP DOWN PROGRAM START/STOP
POWER
E. SHO Time in Seconds
P/N 1010678 Rev. F 09/04
OPERATION (continued)
READY
15
UP DOWN PROGRAM START/STOP
POWER
B. Total Cycle Minutes
READY
00
UP DOWN PROGRAM START/STOP
POWER
F. SHO Time in Minutes
Figure 7. Control Programming Sequence
13
DELUXE FOOD WARMER
10. Press either the Start/Stop or Operate button to
store the changes and to exit the PROGRAM
mode.
NOTE: The Start/Stop or Operate button may be
pressed at any time during programming to store
the changes and exit the PROGRAM mode.
NOTE: If no change is made within 5 seconds at
any time during the programming process, all
changes made up to that point are stored in memo-
ry and the control reverts to the OPERATION mode.
READY
00
UP DOWN PROGRAM START/STOP
POWER
C. Total Cycle Seconds
READY
H2O
UP DOWN PROGRAM START/STOP
POWER
G. H O Cycle
2
READY
SHO
UP DOWN PROGRAM START/STOP
POWER
D. SHO Cycle
READY
0_80
UP DOWN PROGRAM START/STOP
POWER
H. H O Setting
2