Trig (F3); Sys (F4) - Pearl Red Box RBM 20 Owner's Manual

• Prog Chng: Determines if the module will send out Program Change messages to external MIDI devices. When
set to "NOT SENT" (the default), the module will not send any Program Change messages. When set to "SENT,"
the module will send Program Change messages to a connected MIDI device.
• Clock Out: Determines if the module's internal clock will serve as the "master" clock for a connected MIDI de
vice. When set to "NOT SENT" (the default), the module will not send out any MIDI clock information to a connected
device. When set to "SENT," a connected MIDI device will sync to the module's internal clock.
• MIDI Thru: When set to "ENABLED" (the default), the module's MIDI OUT functions as a MIDI THRU. In this
case, a device connected to the module's MIDI IN can send data through the module to a device connected to
the module's MIDI OUT.When set to "OFF," the module's MIDI OUT functions only as a MIDI output for the module itself.

TRIG (F3)

Pressing TRIG (F3) from the Main UTILITIES menu lets you access a page
that contains the various trigger settings for the module.
TRIG
1. Press UTILITIES to enter the main UTILITIES Menu.
2. Press TRIG (F3) to access the trigger settings.
3. Use DEC- / INC+ or the VALUE / TEMPO DIAL to adjust the
settings:
a. Trig Sens: The sensitivity of all the connected triggers – "LOW," "MEDIUM," or "HIGH." Adjusting this
setting lets you roughly set the sensitivity of the entire Kit but conveniently keeps the proportions of your
individual trigger settings. (To adjust the sensitivity of individual triggers,
see the TRIGGER INPUT PARAMETERS section of the TRIG. EDIT MENU chapter.)
b. HiHat * : Select "NOTE+CC#4" or "NOTE ONLY." This determines whether the hi-hat
MIDI note will be sent with or without CC information (CC#4).
c. HH Splash * : Select "SENT" or "NOT SENT." This determines whether the hi-hat "splash" note
(generated by quickly pressing then releasing the pedal) will be sent or not.
d. Cym Choke * : Select "SENT" or "NOT SENT." This determines whether the cymbal "choke" note
(generated by grabbing the cymbal and touching the choke strip) will be sent or not.
* Note: The "HiHat," "HH Splash," and "Cym Choke" parameters allow you to tailor the MIDI output of these
notes, which is useful when using the module with an external hardware or software drum module that does
not support a variable hi-hat pedal, the hi-hat "splash," cymbal choking, etc. Also, even when these param-
eters are set to "NOTE ONLY" or "NOT SENT," the MIDI notes and information you have "disabled" will actually
still be recorded when you record a Sequence, but they will not be sent to the MIDI output.

SYS (F4)

Pressing SYS (F4) from the Main
the module's various system settings.
SYSX (F1)
This page lets you send out the module's settings as a
1. Press to enter the main
UTILITIES
2. Use
CURSOR UP / DOWN
All of the module's memory that can be saved
a. All Memory:
will be saved as a SysEx file.
This includes your trigger settings, Kits, and Sequences.
Only the module's trigger settings will be
b. All Trigger Settings:
saved as a SysEx file.
menu lets you access a page that contains
UTILITIES
Menu.1).
UTILITIES
to move through the menu items:
will be saved as a SysEx file.
(.syx) file to be recalled later.
SysEx
31