Setting The Cutting Height - sunjoe iON16LM Operator's Manual

2. Next, release the quick-lock wheel for the lower handle by
turning it counterclockwise. This will allow you to move
the handle to the required position. Secure the handle by
turning the wheel in the opposite direction (Fig. 2).
Fig. 2
Quick-lock wheel
Fitting the Grass Bag
IMPORTANT! Before fitting the grass bag, ensure that the
safety key has been pulled, the motor is switched off and the
blade has come to a complete standstill.
1. Clip the protective plastic straps onto the support rod
(Fig. 3).
Fig. 3
2. Lift the ejector flap with one hand.
3. With the other hand, hold the grass bag by the handle and
hook it in from above (Fig. 4).
Fig. 4
Ejector flap

Setting the Cutting Height

IMPORTANT! Before adjusting the cutting height, make sure
the motor is switched off and the safety key has been pulled.
1. To set the cutting height on your lawn mower, pull out
the cutting height adjustment lever, move the lever to the
left or right and push it back into one of the six cutting
positions indicated below. Make sure that the lever
engages properly (Fig. 5).
6-Position Height Adjustment:
1. 1.18 in. (30 mm)
2. 1.38 in. (35 mm)
3. 1.77 in. (45 mm)
Fig. 5
Support rod
Protective
plastic straps
Before you begin to mow, check to ensure that the blade is not
blunt and that none of the fasteners are damaged. To prevent
any imbalance, replace blunt and/or damaged blades. To carry
out this check, first switch off the motor and pull out the safety
key.
9
Grass bag
4. 2.17 in. (55 mm)
5. 2.60 in. (66 mm)
6. 3.15 in. (80 mm)
Palanca de
ajuste de altura
de corte