Operation; Adjusting The Cutting Height - sunjoe MJ506E Operator's Manual

NOTE: If the latch is too difficult to flip up, loosen it 1 - 2
full rotations before trying again.
4. Repeat the above instructions to assemble the lower
handle bar on the other side.
5. Slide the extension cord restraint hook onto the upper
handle frame (Fig. 4).
Fig. 4
Extension cord
restraint hook
Upper handle
frame
6. Fit the upper handle frame on the ends of the lower handle
bars, and secure with the upper handle latches with long
bolts, washers, and knobs, as shown. Tighten securely,
then flip latch up to lock (Fig. 5).
Fig. 5
Upper handle
Upper handle
washer + latch
knob
Lower handles
NOTE: If the latch is too difficult to flip up, loosen it 1 - 2
full rotations before trying again.
7. Clip on the cable clips, and insert the cable into the cable
clips (Fig. 6)
Upper handle
frame
Fig. 6
Cable
Grass Collection Bag Assembly + Fitting
The grass collecting bag prevents grass clippings being thrown
across your lawn as you mow.
1. Lift the ejector flap with one hand. With the other hand,
hold the grass collection bag by the handle and hook it
in from above. Make sure the bag rods are hooked in the
slots on both sides (Fig. 7).
Fig. 7
Slot
Grass
collection
bag

Operation

This lawn mower is intended for private residential use to cut
grass in small lawns and gardens. This lawn mower is not
intended to cut grass in public parks, playing fields, farms, or
forests. Do not use this lawn mower for any application other
than that for which it is intended.

Adjusting the Cutting Height

This electric reel mower is equipped with a 5-position height
adjustment system to tailor grass cutting heights from 1.0 inch
to 2.6 inch. To change the cutting height of the grass, follow
the instructions below.
m
WARNING!
Before making these adjustments,
disconnect the power supply to the lawn mower and wait until
the rotating blades have come to a complete standstill.
8
Cable clips
Grass collection
bag rod
Grass collection
bag handle