Digital Dubbing - JVC LYT0291-001B Instructions Manual

To DV IN/OUT
DV cable
(optional)
To DV IN/OUT
RM-V711U
(provided)
T W
PLAY (4)
STOP (5)
To Use This Camcorder As A Recorder . . .
1. Turn the Power Switch to "
2. Connect the DV cable as shown in the illustration and load a cassette to record on.
3. Press the Recording Start/Stop Button to engage the Record-Pause mode. "DV IN" appears on the screen.
4. Press the Recording Start/Stop Button to start recording. "DV IN" changes to "
5. Press the Recording Start/Stop Button again to engage the Record-Pause mode. "
NOTES:
During Digital Dubbing, the image is dubbed using the recording mode selected in the Recording Menu
( pg. 12).
Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current
"SOUND MODE" setting (
Lock Button
Power Switch
Video unit equipped
with DV connector
" while pressing down the Lock Button located on it.
pg. 32).

Digital Dubbing

It is also possible to copy recorded scenes from the
camcorder onto other video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.
1
CONFIRM POWER-OFF STATUS
Make sure the camcorder's power is off.
2
MAKE CONNECTIONS
Connect the camcorder to your video unit equipped
with a DV connector using the DV cable (optional) as
shown in the illustration.
3
START PLAYBACK
Press PLAY (4) to play back the source tape.
4
START RECORDING
While watching the playback on the monitor, engage
the DV connector-equipped video unit's record mode
from the spot on the source tape you want to begin
recording.
NOTES:
It is recommended to use the AC Power Adapter/ Charger
as the power supply instead of the battery pack (
If the remote control is used when both the player and
recorder are JVC video units, both units will perform the
same operation. To prevent this from happening, press the
buttons on both units.
For Digital Dubbing, this camcorder can be connected only
to one device at a time. This camcorder can also be used as
a recorder.
If a blank portion is played back on the player during
dubbing when this camcorder is used as a recorder, this
camcorder enters Record-Standby mode so that an usual
image is not dubbed.
Even though the DV cable is connected correctly, some-
times the image may not appear in step 3. If the above
occurs, turn off power and make connections again.
If "Playback Zoom" (
( pg. 59) or "Snapshot" is attempted during playback,
only the original playback image recorded on the tape is
output from the DV OUT connector.
During Digital Dubbing, the scenes recorded in High Speed
Recording mode are divided into 2, and the image is
displayed both in the upper and lower halves of the screen
( pg. 47).
Be sure to use a DV cable with the noise filter.
pg. 58), "Playback Special Effects"
DV IN
".
" returns to "DV IN".
DV IN
55
EN
pg. 9).
1