Red-Eye Reduction Button; Snapshot Button [Snapshot]; Lcd Monitor Is Opened Fully; Flash - JVC LYT0291-001B Instructions Manual

28
EN
Flash sensor

Flash

SNAPSHOT Button
MENU Button
Display
PAUSE
REC MODE SP
WIDE MODE OFF
ZOOM 40X
DIS OFF
GAIN UP AGC
4 FLASH AUTO
TO DATE / TIME MENU
TO SYSTEM MENU
– – – – – – – – – –
END 6
NOTES:
Do not flash at a person at short range.
In Multi-Analyzer 4, Multi-Analyzer 9 or Nega/Posi mode, the flash is disabled (
The flash does not light when the flash is set to "OFF" on the recording menu and also when the battery remaining
power is low. Moreover, the flash does not light when it is set to "AUTO" on the recording menu with GAIN
UP set to "OFF" (
When taking several snapshots in succession (Motor Drive Mode), the flash lights only during the first one.
Although images shot with a flash tend to look whiter than they actually are, to compensate for this
camcorder automatically darkens the picture when using the flash. When shooting a subject at a distance
where the flash light cannot reach (over approx. 2 m (6.6 ft) ), set the flash to "OFF" to prevent the picture
from becoming too dark.
The color tone changes depending on the background lighting conditions, such as under fluorecent or
halogen lamps.
When you want to change the brightness of the flash, refer to "Flash Brightness Adjustment" (
While charging the flash,
malfunction. This is not recorded. It can take up to ten seconds to charge the flash.
Red-Eye Reduction
Button
Power lamp
Lock Button
Power Switch
Flash ready
indicator
Red-Eye reduction
indicator
Recording Menu
pg. 31) and with Program AE with special effects set to "TWILIGHT" (
blinks and the flash does not light. Although noise may appear, this is not a
RECORDING
Snapshot Flash (Auto Flash)
During Full Auto mode, or Manual mode when "FLASH"
is set to "AUTO" in the Recording Menu, the flash
automatically lights at the subject if it's dark (
when taking a snapshot in Record-Standby.
By setting "FLASH" to "ON" or "OFF" in the Recording
Menu, the flash can be activated or deactivated on demand.
1
ENGAGE RECORD-STANDBY
Set the Power Switch to "
while pressing down the Lock Button located on the
switch, and pull out the viewfinder fully or open the
LCD monitor fully.
If the Power Switch is set to "
.... go to step 5.
If the Power Switch is set to "
.... go to step 2.
2
ACCESS RECORDING MENU
Press MENU. The Recording Menu appears.
3
SELECT FUNCTION
Rotate the Select Dial to move the highlight bar to
"FLASH", then press it.
4
SELECT FUNCTION PARAMETERS
Rotate the Select Dial to display the desired param-
eter ("AUTO", "ON" or "OFF") and press it. "FLASH"
stops blinking and setting is complete. Press the
Select Dial once. The normal screen reappears.
5
TAKE SNAPSHOT
Press SNAPSHOT.
To Reduce The Red-Eye Effect Of The Subject's Eyes . . .
.... it is recommended that you use this function when
shooting a person. When "
Red-Eye Reduction Button (3). The
reduction indicator lights, then press SNAPSHOT. The
flash lights twice. The first flash is for reduction of the
human eye's red reflection and the second flash is for
actual recording.
Advanced Features (cont.)
", " ", "5S" or "
" . . .
", "5S" or "
" appears, press the
pg. 27).
pg. 36).
appears)
"
" . . .
Red-Eye
pg. 29).