Table of Contents
Advertisement
60
EN
SYMPTOM
31. An error indication
(E01 — E06) appears.
32. The charge indicator on
the AC Power Adapter/
Charger does not light.
33. The recording mode
indicator "LP" blinks.
34. Picture does not appear in
the viewfinder.
35. When the image is printed
from the printer, a black
bar appears at the bottom
of the screen.
36. The power lamp blinks.
37. There are disturbances in
audio.
TROUBLESHOOTING
POSSIBLE CAUSES
31. •A malfunction of some kind
has occurred. In this case the
camcorder's functions
become unusable.
32. •The temperature of the
battery is extremely high/low.
•Charging is difficult in places
subject to extremely high/low
temperatures.
33. •This occurs when recording
in the LP mode is not
available. After the indicator
blinks, the recording mode
switches to "SP" and
recording goes on.
34. •The lens cover is closed.
35. •This is not a malfunction.
36. •The camcorder was turned
on when the battery power
was almost gone.
37. •If Audio Dubbing has
been performed
repeatedly on the same
portion of the tape,
disturbance to the sound
may result.
CORRECTIVE ACTION
31. • Remove the power supply
(battery pack, etc.), clock
battery and wait a few
minutes for the indication to
clear. When it does, you can
resume using the camcorder.
If the indication remains
even though you repeat the
above two or three times,
please consult your nearest
JVC dealer.
32. • To protect the battery, it is
recommended to charge it in
places with a temperature of
10°C to 35°C (
33.
————
34. • Open the lens cover
(
pg. 14).
35. • By recording with Picture
Stabilizer activated
(
pg. 16) this can be
avoided.
36. • Replace with a charged
battery pack (
37. • Use a new, or infrequently
used, tape for Audio
Dubbing (
pg. 54, 55).
(cont.)
pg. 67).
pg. 6)
Advertisement
Table of Contents
