Table of Contents
Advertisement
24
EN
Date/Time Menu Explanations
ON SCREEN
DISPLAY
DATE/TIME
System Menu Explanations
PHOTO MODE
TALLY
WIND CUT
SOUND MODE
ID NUMBER
DEMO. MODE
: Factory-preset
Keeps the camcorder's display from appearing on the connected TV
OFF
screen.
ON
Makes the camcorder's display appear on screen when the camcorder
is connected to a TV.
ON
Makes the date/time settings appear in the camcorder (
OFF
Keeps the date/time settings from appearing in the camcorder.
Allows you to set the current date and time (
Allows you to set the parameters for "FULL", "FRAME", "PIN-UP", "MULTI 4" and
"MULTI 9" recording (
The tally lamp comes on to signal the start of recording.
ON
OFF
The tally lamp remains off at all times.
Disengages the function which cuts down on noise created by wind.
OFF
ON
Helps cut down on noise created by wind.
•"
•The quality of the sound will change. This is normal.
32 kHz
Enables recording of stereo sound on four separate channels, and is
recommended for use when performing audio dubbing.
48 kHz
Enables recording of stereo sound on two separate channels.
This number is necessary when connecting the camcorder to a device such as a
computer using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting
is 07.
Automatic demonstration will not take place.
OFF
ON
Demonstrates certain functions such as Programme AE with special
effects, etc., and can be used to confirm how these functions operate.
When "DEMO. MODE" is set to "ON" and the Recording Menu is
closed, demonstration starts.
NOTES:
If a tape is in the camcorder, the demonstration cannot be turned
on.
By turning off the camcorder, "DEMO. MODE" is set to "OFF"
automatically.
RECORDING
pg. 20).
" appears.
Advanced Features (cont.)
pg. 9).
pg. 19).
Advertisement
Table of Contents
