Table of Contents
Advertisement
Date/Time Settings
Date and time will automatically be recorded on tape at all times. It is your choice to display it or not during
playback (
pg. 51).
Lock button
Power lamp
Power Dial
Select Dial
1
SELECT OPERATION MODE
Set the Power Dial to " " while pressing down
the lock button located on the dial, and pull
out the viewfinder fully.
•The power lamp comes on and the
camcorder is turned on.
2
ACCESS RECORDING MENU
Press MENU. The Recording Menu appears.
3
ACCESS DATE/TIME MENU
Move the pointer and highlight bar to "TO
DATE/TIME MENU" by rotating the Select Dial.
Press the Select Dial and the Date/Time Menu
appears.
4
INPUT DATE AND TIME
Move the pointer and highlight bar to "DATE/
TIME" by rotating the Select Dial. Press the
Select Dial and "day" is highlighted and begins
blinking.
Rotating the Select Dial, input the day. Press
the Select Dial. Repeat the procedure to input
the month, year, hour and minute.
•Press the Select Dial twice when the pointer
and highlight bar are set to "RETURN" to exit.
MENU button
Regarding Built-in Rechargeable Battery
To store the date/time in memory, a rechargeable
clock lithium battery is integrated in the camcorder.
While the camcorder is connected to an AC outlet
using the AC Charger Station, or while the battery
pack installed in the camcorder continues to supply
power to the camcorder, the clock lithium battery is
always charged. However, if the camcorder is not
used for approx. 3 months, the clock lithium battery
will become discharged and the date/time stored in
memory will be lost. When this occurs, first connect
the camcorder to an AC outlet using the AC Charger
Station etc. for over 24 hours to charge the clock
lithium battery. Then perform the date/time setting
before using the camcorder.
It is also possible to use the camcorder without the
date/time setting.
NOTE:
If you don't exit the Date/Time Menu, the clock
display will not move but the camcorder's internal
clock continues to operate. Once you close the
menu, the date and time begin operation from the
current date and time, with no delay or loss.
Display
REC MODE
SP
WIDE MODE
OFF
ZOOM
40X
DIS
ON
GAIN UP
AGC
4
TO DATE / TIME MENU
TO SYSTEM MENU
END
Recording Menu
ON SCREEN
OFF
DISPLAY
ON
4
DATE / TIME
1 . 1 . 00
0 : 00
RETURN
Date/Time Menu
11
EN
Advertisement
Table of Contents
