Insert Editing (Video) - JVC LYT0087-001B Instructions Manual

66
EN
COUNTER R/M
PLAY/PAUSE
REW
M–0:12:34
Viewfinder
RM-V709U
(provided)
USING REMOTE CONTROL UNIT
FF
STOP
Power Switch
Insert editing
indicator
Tape Counter
System Select Switch
START/STOP
REW
PAUSE
INSERT
PLAY

Insert Editing (VIDEO)

You can record a new scene into a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
NOTE:
Use the RM-V709U remote control unit to perform this
procedure.
SELECT MODE
1
Set the System Select Switchc to "VIDEO", set the
Power Switch to "PLAY".
FIND EDIT-OUT POINT
2
Play back the tape, locate the Edit-out point and
press PAUSE on the camcorder or the remote
control.
RESET COUNTER
3
Press and hold COUNTER R/M for more than
1 second to reset the tape counter, then press again
for less than 1 second and make sure "M" appears.
FIND EDIT-IN POINT
4
Press REW to go a little beyond the beginning of the
scene you want to replace, press PLAY to view the
recorded tape, and press PAUSE exactly at the point
where the new scene should start.
ENGAGE INSERT EDITING MODE
5
Press and hold INSERT, and without releasing
INSERT, press and release PAUSE. The Insert mode
is engaged. When the scene the camcorder is aimed
at appears on the screen, go to the next step.
BEGIN INSERT EDITING
6
Press START/STOP. When the counter reaches
"0:00:00", editing stops automatically and the
camcorder enters the Insert-Pause mode.
END INSERT EDITING
7
Press STOP.
NOTES:
After step 5, Retake (
The tape may stop slightly before or after the desig-
nated end point, and noise bars may appear. Neither
indicates a defect in the unit.
Only video signal is recorded in the Insert Editing
mode.
pg. 17) can be performed.
(cont.)