Chassis Reassembly - Motorola GTX Service Manual

Radio Disassembly/Assembly
Radio Reassembly
4. Fold the LCD flexible circuit (Figure 1-11).
Make sure the LCD flexible circuit is outside.
5. Place the front housing shield into the front
housing using the four slots on the front
housing wall as the guide (Figure 1-10).
Figure 1-10. Place Front Housing Shield
Into Front Housing
6. Press down the shield at the four tabs until
tabs lock into the front housing catches.
7. Slide in the lightpipe (Figure 1-11).
LCD flexible
circuit
Figure 1-11. Slide In The Lightpipe

Chassis Reassembly

1. Place chassis on a flat surface with the battery
rails downward.
2. Insert the flexible circuit tail end (marked "RF"
into the ZIF connector on the RF board and
lock the connector by engaging the latch
(Figure 1-12).
3. Insert main board into chassis using alignment
pins as a guide (Figure 1-12).
4. Place front shield on main board using tabs as
a guide (Figure 1-12).
5. Press down on front shield until chassis, main
board, and front shield are seated tightly
together.
1-4
GTX/GTX LTR/LTS 2000 Portable Radios Service Manual
Figure 1-12. Align Pins
6. Hook locking clips first to the chassis tab, then
push clips over on shield with thumb until
clips lock into front shield holes (Figure 1-13).
Figure 1-13.
7. Replace chassis gasket (Figure 1-14).
Figure 1-14. Replace Gasket
68P02948C90-O
Reinsert Locking Clips
February 1997