Initial Inspection; Transportation & Set-Up - PowerTek 12-13 Operation & Maintenance Manual

INITIAL INSPECTION

INSPECTION
Upon receiving your stump grinder, inspect and report any shipping damage to the carrier immediately. PowerTek is
not responsible for damage during transportation.
TIRES
Inflation pressure may change with temperature and or altitude. Check and adjust tire pressure to the tire
manufacturer's recommended tire pressure as marked on the tire of the stump grinder.
ENGINE
The stump grinder engine was shipped from PowerTek with the proper amount of oil. However, you should double-
check the level and add to or change the oil if conditions warrant. (see Engine Operators Handbook for full details).
PRE-USE INSPECTION
Check for any loose bolts or parts before starting or first use.
PREPARATION:
Unit should not be operated until the owner's manual is read, all safety decals are noted and the user has complete
knowledge of all controls.
TRANSPORTATION & SET- UP
TRANSPORTATION
It is the responsibility of the owner and/or operator to be aware of and abide by all applicable state and
local regulations regarding transport of equipment and trailers (i.e. lights, tags, registration, etc.). Pick-up
truck or similar vehicle may be used to transport the machine. The stump grinder may also be transported
on any suitable trailer. Make sure it is properly secured.
SET-UP
The following procedures should be performed before each use of the stump grinder.
Check the unit for any loose parts. Tighten nuts and bolts and make sure all safety guards and devices
(Belt Guard, Brakes, Kill Switch and Clutch Switch) are securely in place and working. Please check all
cutters to make sure they are tight.
Check the cutters for dulling. It is important to keep cutters sharpened by grinding or replacing them.
Dull cutters will cause excessive engine wear and poor performance. See the Maintenance Instructions for
details.
Check the oil and fuel level in the engine. Follow the Engine Operators Handbook if fluid needs to be
added or changed.
Check the air filter. The air filter should be cleaned of dust regularly. See the Engine Operators
Handbook for details.
Check the tension of the engine belts. The cutter wheel belts should have a deflection at the center of
3/8", under 5-lbs. deflection. Recheck belt tension after every use.
6
POWERTEK
POWERTEK