JVC GZ-MG70E Instructions Manual page 9

M5E6PAL.book Page 9 Friday, August 26, 2005 8:16 PM
Attaching the Core Filter
Attach the core filters to the cables. The core
filter reduces interference.
1
Release the stoppers on both ends of the
core filter.
Stopper
2
Run the cable through the core filter, leaving
approx. 3 cm of cable between the cable plug
and the core filter.
S-Video/Audio/Video/USB cable
Wind the cable once around the outside of the
core filter as shown in the illustration.
Core Filter (Large)
3 cm
DC cord
Wind the cord twice around the outside of the
core filter as shown in the illustration.
Core Filter (Small)
3 cm
Wind the cable so that it is not slack.
3
Close the core filter until it clicks shut.
S-Video/Audio/Video/
USB Cable
NOTES:
Take care not to damage the cable.
When connecting a cable, attach the end with the
core filter to the camera.
LCD Monitor
Push the release button
monitor fully. It can rotate 270°.
Wind once.
Wind twice.
DC Cord
MasterPage: Start_Right
GETTING STARTED 9
EN
and open the LCD