Advertisement
Page 8
Q
UICK
To familiarize yourself with the basic functions of Chili, follow the six steps below. These steps will walk you
through the basic playback features that are commonly used for playback of a CD, Floppy or Internal Demo. Chili
utilizes the same buttons for other features. These features will be discussed in detail in the following sections.
Step 1.
Press Power
Step 2.
Press Play
Step 3.
Enter
Adjust Volume
Step 4.
Right
Advance Song
Step 5.
Left
Previous Song
Step 6.
Press Stop
Play
Owners Manual
S
TART
So, to play a CD: Push the
Source button, Dial In
QRSCD, Push Enter.
Press "Power" to turn the unit "ON" or "OFF". The unit will
default to the last played source.
Push play and the song begins. Push pause and the song
will pause.
To increase volume, turn the dial to the right, to decrease
volume turn the dial to the left.
To advance to the next song Press the "Right" button.
To return to the beginning of the song Press the "Left" but-
ton once . Press twice to go to the previous song.
To end playback Press "Stop".
Once a track has been selected and "played" the unit will
then continue to the next track until it reaches the end of
the media.
For Technical Support Call 1-941-597-5888
U
PGRADING
Downloading an update from the website
•
Create a folder under you're My Documents folder called QRS, and one called QRS Manu-
als. Go online to http://www.qrsmusic.com.
•
Click on QRS Software Update link under the picture of Chili
•
Click on the upgrade file QRS610.bin version x.xx.
•
Your computer will ask you where you want to put it, send it to your QRS folder and push
enter.
•
When it is done downloading, copy the QRS610.bin just downloaded to a blank floppy.
•
Rename the file on the floppy QRSupdat.bin.
•
While you are at the sight you can also download the latest manuals to the QRS manual
folder you created.
For units where the display reads Boot Loader 0.02
•
Hold down the following 4 buttons at the same time - "audio", "metronome", "source",
"setup" and Power up the Chili (This will erase all existing presets you may have had).
•
Holding the four buttons down should be done if you are jumping from one major revision to
another. For example from 3.xx to 4.xx. It is not required if you are jumping from say 4.45 to
4.48.
•
If this is a minor update turn the unit on without holding the buttons.
•
Insert the QRSUpdat disk and hold the clear button down for more than 6 seconds.
•
The boot code will now flash QRSUPDAT.BIN, (about 8xxK).
•
After the upgrade has finished, remove the disk. You are finished upgrading and the install-
ing latest code.
•
Turn the unit off then on.
•
If you have a record strip present be sure to go to "Setup - Record Strip - Present " .
•
If you have any questions be sure to give us a call. 941-597-5888.
•
If you get errors try it again, or make another copy on a reformatted disk.
Page 61
Advertisement
