Changing The Tool - Fein WSG10-115T Instruction Manual

3 41 01 121 21 0.book Seite 16 Montag, 22. August 2011 1:11 13
en
16

Changing the tool.

Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Mounting a grinding disc (Figure 5) WSG10-115T/WSG14-125T/WSG14-150T/
WSG14-70ET.
Only press the locking button when the
motor is not running.
Press the locking button and keep it
pressed down. Undo the threaded flange
using the face spanner.
Completely unscrew the threaded
flange.
Change the used accessory or insert a
new one.
Fig. 5
Locking button
Note: Pay attention to the mounting direction
of the inner flange, which can vary depending
on the thickness of the grinding disc
(Figure 5).
Threaded flange
In so doing, make sure that the grinding
tool is centred properly between the
inner and threaded flange.
Screw the threaded flange in again by
hand.
Press the locking button and keep it
pressed down. Screw the threaded
flange tightly using the face spanner.
Inner flange
6 mm
1/4 in
6 mm
1/4 in