Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ice Trike 2012
Summary of Contents for Ice Trike 2012
-
Page 2: Table Of Contents
2012 Trike Assembly Manual 1.0 Introduction ........................................1.1 Overview ........................................2.0 Assembling your trike ....................................2.1 Adjusting and closing quick-releases ..............................2.2 Unpacking ......................................... 2.3 Unfolding ........................................2.4 Fit and set the handlebars to an approximate position ........................... 2.5 Install and connect the rear derailleur ..............................2.6 Fit the front wheels and brakes ................................ -
Page 3: Introduction
We hope you enjoy owning and riding your ICE This manual has been written to help you set If you have never worked on a bike before, trike as much as we like making these great up and use your trike. -
Page 4: Unpacking
2.2 Unpacking First of all, open the box, unwrap and lay out the pieces, inspecting for any damage that may have occurred during shipping. The black square of fabric-covered rubber is not a piece of packaging. Do not throw it away!! You should have all the items shown on this page, as well as any accessories you have... -
Page 5: Unfolding
2.3 Unfolding Unwrap the trike main cruciform and sit it on a flat surface, preferably with something soft If you have ordered a model with a 26 inch or (cardboard/carpet) under the frame to protect the paint. 700c rear wheel, then insert the rear wheel fully in the back of the frame and tighten the quick release fully. -
Page 6: Fit The Front Wheels And Brakes
2.6 Fit the front wheels and brakes There are 3 different front brake/wheel combinations, depending on which model you have ordered. Identify which type of wheels & brakes you have, and which are the left-hand and right- hand wheels (they are marked with a label on the spokes/rims). -
Page 7: Fit Front Avid Bb7 Disc Brake Wheels And Brakes
2.6b Fit front AVID BB5 disc brake Follow the procedure above up to where the Squeeze the brake lever to compress the brake Back the adjustment knob off cable has been clamped onto the actuating pads firmly on the rotor. While still holding the (counterclockwise) until the rotor spins freely. -
Page 8: Fit Front Hydraulic Brakes Wheels
2.6d Fit front drum brake wheels Identify the left-hand and right-hand wheels (the labels are fastened to the spokes). Locate CAUTION: the front wheel 12mm axle bolts with their Make sure the brake plate is washers and 6mm nylock nuts. Remove the located on the pin as this stops the zip tie. -
Page 9: Fit The Seat
2.8 Fit the seat 2.9 Fit the front boom to an approximate position If you have an ‘Adventure’, you will need Fit the front boom into the frame taking care not to raise the seat mount extension. Put the to damage the plastic shim located inside the mounting bolts in the position shown in the front of the main frame. -
Page 10: Install The Front Derailleur Cable
2.14 Install the front derailleur cable The front derailleur cable can be identified by the cable guide tube (chromed ‘noodle’). Pass the cable guide up through the rear (larger) hole on the underside of the front boom, so that it just pokes out of the hole on the top face of the boom. -
Page 11: Fit The Chain
2.16 Fit the chain Note: before doing the next section you will need to have set the boom length as described in section 2.13. Twist the right hand rear shifter to the “1” position so that the rear derailleur lines up with the largest rear sprocket. Twist the left hand front shifter to the “H”... -
Page 12: Check The Gear Shifting
When you’ve finished adjusting the chain length, TIP – get an extra pair check at the pulley plate where the chain enters and leaves the chain tubes. The plastic clips of hands to help with this. should be adjusted vertically so the chain is Make sure that any links you alter running centrally where it enters and exits the with the chain link remover are not... -
Page 13: Fit The Mirror
Inspired Cycle Engineering warrants, to the to make sole determination of whether any 3.2 Serial Number original owner of each new ICE tricycle that failure or damage claimed under warranty was the frame, seat, and steering components are caused by material or manufacturing defect, and... -
Page 14: Liability Information
(+44 1326 379879 outside UK) in this manual, please contact your dealer or not required by law, some equipment (such as ICE. It is up to you to know and obey traffic laws helmets and lights) can increase your personal E-mail: sales@icetrikes.co... -
Page 15: Appendix A: Tightening Torques
Appendix A: Tightening torques Fastener Uses Hex Key (mm) lb-ft Front derailleur clamp bolt Front derailleur cable clamp bolt Chainset - central crank bolt 35-50 25-36 Chainset - chainring bolt 5 + Tool 8-10 Chainring guard bolt 4.5-6 Main frame clamp bolts 8-10 Mudguard adjusters 4.5-6...
Need help?
Do you have a question about the Trike 2012 and is the answer not in the manual?
Questions and answers