Quick Configuration; Starting Quick Configuration; Example Using Windows 3.1 Terminal Application - 3Com AccessBuilder 500 User Manual

1-24 C 1: G
HAPTER

Quick Configuration

This section describes how you can configure the unit to bridge or route
over ISDN links to suit most networking requirements using a simple
forms-based user interface. If you want to connect to a remote site using
leased line WAN links see
If you are unsure about the networking configuration you require, see
"Examples of Typical ISDN Networking Applications"
more information.
IMPORTANT The Quick Configuration menu option is designed to be used
only when you set up the unit for the first time. If you want to make any
changes to the unit' s configuration at a later stage, use the management
system menus to make these changes. For more information, see the
AccessBuilder ISDN Access Router Software Reference guide.

Starting Quick Configuration

1 Using a VT100 compliant terminal emulator, setup the terminal
emulation to VT100 with communications parameters set as follows;
select the COM port to be used for data transmission, 9600 bits/s – 8
data bits – 1 stop bit – no parity, with flow control set to none.

Example Using Windows 3.1 Terminal Application

Start the Windows 'Terminal' application. Using a mouse, click on
Settings in the status bar to reveal the menu.
From the menu:
a Select the Terminal Emulation dialog box; confirm that DEC VT-100
(ANSI) is selected.
b Select the Communications dialog box; check the communications
parameters are set as above.
c Select the Terminal Preferences dialog box; confirm that all
check-boxes have been cleared.
S
ETTING TARTED
"Setting Up a WAN Link" on page 1-39.
on page 1-41 for