Playback; Record-Standby; Still Playback - JVC GR-SXM195AS Instructions Manual

RECORDING
Set REC MODE, S-VHS (S-VHS ET), TAPE
LENGTH and DATE/TIME in SYSTEM MENU.
( pg. 18 – 22, "MENU SETTINGS")
1
Remove the lens cap. Set the Power Switch
to " " or " " while pressing down the Lock Button
!
located on the switch.
Shooting while using the viewfinder: Make sure
the LCD monitor is closed and locked.
Shooting while using the LCD monitor: Make
sure the LCD monitor is fully open.
The camcorder enters the Record-Standby mode
q
and "PAUSE" is displayed.
• The viewfinder and LCD monitor cannot be used
simultaneously on this camcorder. Therefore,
when opening the LCD monitor and tilting it
upward to 180°, you cannot view any image in the
viewfinder, however you can shoot yourself while
viewing your own image in the LCD monitor.
2
Press the Recording Start/Stop Button
appears while recording is in progress.
• To stop recording, press the Recording Start/Stop
0
Button . The camcorder re-enters the Record-
Standby mode.
To Adjust The Brightness Of The LCD Monitor,
When the Power Switch
"LCD BRIGHT" in SYSTEM MENU (
When the Power Switch
"OFF", this adjustment cannot be performed.
0
.
@
is set to " ", adjust
pg. 18, 22).
@
is set to " " or

PLAYBACK

1
Load a tape (
Cassette").
2
Set the Power Switch
pressing down the Lock Button
@
switch. To start playback, press 4/6
To stop playback temporarily (Still Playback), press
^
. To stop playback, press 5
4/6
w
to rewind, or 3
High-speed picture search (Shuttle Search) is
possible by pressing 2
playback (holding 2
playback continues search until released). To
resume normal playback, press 4/6
For VIDEO RECORDING/VIDEO PLAYBACK
• The camcorder shuts off automatically after about
5 minutes in the Record-Standby or Stop mode.
To turn on again, set the Power Switch
"OFF", then to "
8 • When the Power Switch
" " and the LCD monitor is opened at an angle
of 60 degrees or more, the LCD monitor switches
on and the viewfinder switches off automatically
to save power.
• The playback picture can be viewed in the
viewfinder (with the LCD monitor shut), on the
LCD monitor or on a connected TV (
"Connections To A TV/VCR").
• To remove the indications,
OSD OUTPUT in SYSTEM MENU.
• To control the speaker volume, rotate the MENU
1
Wheel towards "+" to turn up, or towards "–" to
turn down. While shooting, sound is not heard
from the speaker.
• Noise bars appear and pictures may become
monochrome or darken during Shuttle Search.
This is normal.
11
pg. 8, "Loading/Unloading A
@
to " " while
!
located on the
^
.
e
. Press 2
&
to fast-forward the tape.
w &
or 3 during
w &
or 3 down during
^
.
", " " or " ".
@
is set to "
pg. 21, DISPLAY or
@
to
", " " or
pg. 15,