Advertisement
The quick guide is for quick installing and connecting the Full HD Lightweight IP Dome Camera. For details, please
refer to the camera's User Manual.
Camera's Connectors
Connector
Reset Button
BNC
Alarm I/O
Audio I/O
Power
RJ-45
IP Dome Camera Installation
Please follow the instructions below to complete IP Dome Camera installation.
Power up the Camera
To power up the IP Camera, please plug the camera's DC 12V/ AC 24V cable into the power terminal block.
Alternatively, connect the Ethernet cable to the camera's PoE port and plug the other end of the cable into a PoE
switch.
NOTE: If using PoE, make sure Power Sourcing Equipment (PSE) is in use in the network.
Ethernet Cable Connection
Connect one end of the CAT5 Ethernet cable to the RJ-45 connector of the IP Dome Camera, and the other end of the
cable to the network switch or PC.
NOTE: In some cases, you may need to use an Ethernet crossover cable when connecting the IP Dome
Camera directly to the PC.
Pin No.
-
-
1
2
3
4
1
2
3
4
1
DC 12V
2
3
1
AC 24V
2
3
-
Definition
Remarks
Restore to factory default
Analog Video Output
Output＋
Output－
Alarm connection
Input＋
Input－
Input
GND
Two-way audio transmission
Output (R)
Output (L)
Power
Reserved
GND
Power connection
Power-1
Earth GND
Power-2
10/100 Mbps Ethernet/ PoE
Full HD Lightweight IP Do
Advertisement
